Fi light coming on, bike will not start, no fuel to injectors

SOURCE: My signal lights, hazard lights, and tail light aren't working.

Check the rear bulbs.If they are working (brakes+lights) check the wires.For the turn signals, override the flasher relay.If they are coming on then you need to replace the relay.If not then check the left hand side clip on switch.

SOURCE: suzuki gsxr k6 600 fuel injectors problems

The display is really FI as in Fuel Injection. The fuel injection computer has sensed a fault in the Injection system. You will need to ride the bike to a dealer and have them read the fault codes. It is probably just something minor. Major faults will not allow the bike to run. You will not hurt the bike if you ride it.

Can I get a “very helpful” rating on this answer?

SOURCE: Troubleshooting 2005 Suzuki Boulevard C50 Motorcycle, Support & S

there is a set of fuses ....... when standing facing the side of the bike that has the clutch on it.... look down at the section of bodywork rearmost (closest to the rear wheel) this section can be unscrewed. in this you will find the relay for the starter motor and the indicators. as well as a small box type containing a number of fuses.

SOURCE: Where is the fuse box located on a 2004 Suzuki Intruder Volusia?

MOST OF THE TIME THE FUSE BOX IS UNDER THE SEAT AND NOT HARD TO GET TO

Testimonial: "I haven't had time to check it out, but If it's there, then you will have been very helpful. Thank you, Pearlie Mae"

SOURCE: When I start riding after about a mile or two the

FI stands for Fuel Injecton. Your fuel injection sensors have found a problem and the on-board computer chip is telling you. You must have a dealer read the computer code to find out what the problem is.
Could you take a moment and rate my answer? Thanks!

Testimonial: "thanks, I had someone else tell me the same thing, but it was a dealer and I just thought he wanted $$$. But you have helped me. "