What is the best way to set the air fuel mixture on a Honda vt100 Shadow Sabre?
SOURCE: settings needed for mixture screws
Turn both screws inward and seat them GENTLY. Now turn both screws one and one half turns outward. This is the factory setting.
Please rate this solution as a "FixYa" Thanks!
SOURCE: looking for the air fuel mixture screws on carb any help?
[IMG]http://i199.photobucket.com/albums/aa59/88gixxer/100_4177.jpg[/IMG]
SOURCE: how to change sparkplugs on honda shadow motorcycle
VT1100 has two spark plugs per cylinder, the sparkplug caps are snap-ons so they're fairly easy to remove. You need a spark plug socket wrench to remove and replace the spark plugs.
SOURCE: 2003 honda shadow spirit vt750 carbs
It is different then most other carbs. DON"T DRILL ANY BRASS HEADS LOOKING FOR THE AIR FUEL MIXTURE. The air fuel mixture is the only adjustment you can make. It is located on the bottom side of the air intake, right behind the air filter box. It looks like a 1/4" flat metal plug. Do NOT drill this. There is no slot for a screw driver. There is a tool which is no more then a small piece of pipe that fits over this plug and you turn it in till seated, gently. Count the turns. Back out to 2 and a half turns, thats normal. Or if you no that you need more fuel injected, simply turn the screw OUT 1/4 or 1/2 turn and try it. GOOD LUCK (Its not hard)
There is no drilling to be done. Hope i didnt scew something up on mine......
SOURCE: how to check water level for my 2002 honda shadow sabre
the easiest way to see the coolant level is to shine a flash light up from underneth the plastic tank, located between the the engine and rear tire. now follow the fillcap located above the right side passenger foot peg. there will be a vertical one inch slot in a chrome cover. behind this slot are two very faint lines . one low, one high about a half inch apart. I found that carefully tilting the bike to the right makes it easy to see just how low the coolant is. a really small diameter piece of tubeing jammed into a tiny funnel will prevent a mess when topping off.
1,875 views
Usually answered in minutes!
×