SOURCE: hONDA VARADERO 125. Changing rear brakde pads but
do they have a seperate fluid reservoir? if so remove the cap and try. if system is pressurised it wont go back. or open the bleed nipple to relieve pressure, you will have to bleed the system after though.
SOURCE: honda varadero 1000 problem
They can be removed and cleaned or replaced.
They cannot be fixed.
They usually put out about a 0-5 volt pulse when
working.
SOURCE: how do you fit a centre stand on a Honda Varadero
take off the gear lever look under it you will see a engine bolt that wen you remove is very close to the gear lever then u know thats the wright one mount the fittings for the stand with the alan key bolts they can be a bit fiddley put the springs on the stand then mount it with the shaft you will have to pull the stand a bit then wen you have it on move the right exhaust clamp round so it doesnt hit the stand.and re fit the gear lever
SOURCE: Honda Varadero 125. Not starting.
Hi !
First check if the current is coming from ignition coil....
If YES ... then the spark plug is burnt(shorted) Get new plugs.
If NO... then there could be a problem with the ignition coil itself Or the coil in the dynamo is burnt.... Regards
Berry
SOURCE: on my honda 125cc varadero the front plug is threaded how do i sort it
If you're lucky a thread chaser may sort it...but really the best option is to remove the head and fit an insert (e.g. helicoil )
114 views
Usually answered in minutes!
×