No ckeck engine lite or codes at any time. After first time, replaced spark plugs, fuel and air filters. Did it again, replaced ignition coil pack. checked and had voltage on pin 6 &10 on the ignition coil pack. waited 35 min. and started. replaced battery. no change and still no codes or ck engine lite. It only happens when the car is hot. Tried letting it sit and idle for over an hour, no problem. Drove it 8 mi. stalled, sat 40 min. started and drove 6 mi. stalled, sat 35 min. started and drove 3 mi and parked it.
Hello.i had similar problem.replaced ignition coil+cranksensor,driven it for several months now.a.ok.
Have you check the O2 sensors? How baout cleaning the MAF and Throttle body? Thermostat?
How does the temp gauge look whn it stalls?
1,144 views
Usually answered in minutes!
I just bought my ranger rover 2000 from an auction I was told it need the ignition fuse. We drove it home no problem about 19 mi. when I went back out to start it a couple of hours later it died. would not start for a couple of hours. After finding the reset switch it did restart then in about 1- min died again when we turned off the key back windsheild wiper and a lot of the other thing came on in the car. after finally getting it shut off as soon as we opened the passenger car door to get out the windsheild wiper came on again. Is this an ignition fuse or what is going on Seems possessed
×