SOURCE: just need the height setting for the floats the
YOU CAN ADJUST FLOATS WITHOUT SPECIAL TOOLS. ALL YOU NEED IS A FOOT LONG PIECE OF CLEAR TUBING, SIZED TO FIT THE BOWL DRAIN. SET FLOATS AS CLOSE TO WHAT THEY WERE WHEN YOU REPLACED IT. INSTALL THE BOWL AND PUT THE TUBE ON THE DRAIN. OPEN THE BOWL DRAIN SCREW WHILE HOLDING THE TUBE UP BESIDE THE CARB. WHEN YOU GET THE TUBE BESIDE THE CARB ASSY., THE GAS IN THE TUBE SHOWS YOU THE EXACT LEVEL OF FUEL IN THE BOWL. FROM THIS YOU CAN MAKE ANY ADJUSTMENTS NECESSARY FOR CORRECT LEVEL. THE LEVEL SHOULD BE RIGHT BELOW THE PLANE WHERE THE BOWL MEETS THE CARB BASE.
SOURCE: carbs leaking
all carbs have floats.it a cv type carb,with a big diaphram for the slide.real easy carb.to work on.if you have any mechanical knowledge.get a manual if not go on internet,and plenty of vendors for *** bikes that sell factory parts look up yours,and the carb will give you a breakdown of it.harley does not have any parts look up like *** bikes.sound like the carb needs cleaning or needle and seat is wore out
SOURCE: twin mikuni carb adjustment
You can make a duel carb sync tool for about $2
Here is a link to a walkthrough for making the sync tool
CARB SYNC TOOL
Here is a link to a walkthrough for doing the carb sync
CARB SYNCHRONIZATION
Don't worry about the air-fuel mixture. It doesn't need to get adjusted.
1,188 views
Usually answered in minutes!
×