How can I change the car oil

Basic procedure for almost all vehicles:
Warm engine to operating temperature. (Hot oil drains more quickly and more completely) Raise vehicle enough to crawl under it on your back (secure with wood blocks or jack stand so it doesn't slip off jack) set parking brake to avoid roll. Get a suitable container for used oil, (at least 5QT capacity) Locate oil pan, will have a plug with a bolt head on it on bottom corner of pan. (usually middle bottom of the engine in location) Loosen and remove oil plug being careful not to get hot oil on your hand. (gloves recommended) Locate oil filter on either underside or toward the side of engine. Remove oil filter with oil filter wrench. (they are usually on too tight to remove by hand) Allow to drain thoroughly for about 10 minutes. Coat new oil filter gasket with fresh motor oil. Screw oil filter on until contact with housing , then an additional 1/4 turn. Replace oil plug. Tighten to 45 ft lbs, or pretty tight, do not over tighten. Lower vehicle. (On level ground) Fill engine with correct weight oil (probably 10W-30W for yours) 4 QTS. Remove oil check dipstick and wipe. Start motor, allow to run for 30 seconds to fill up oil filter and circulate well. Shut off engine, wait 1 minute for oil to drain back into the oil pan, then check oil level with dipstick. Add more as needed to reach full mark on dipstick. (4.5 QTS for V6, 5 QTS for V8 usually) DO NOT OVERFILL! Start motor, check for leaks under vehicle. If ok, you are done. I use the 5QT containers of oil (cheaper too) and then put used oil back into empty container and take to a recycling station for disposal.