This is my first bike so I am very unfamiliar with whole logistics . thanks
SOURCE: brake light does not work
remove the bulbs step on the brake and ck for power at the terminals inside the socket if no power back track the wires and look for a break in the wires.use a didgital volt meter and ck for continuity through the switches( unplug the switch and put the probes to both terminals one on each the meter should beep ---switch good.........
no beep switch bad) also ck the bk. light relay ,not sure where it is at....more extensive problem ??? the dealer sells service the manual with all the wireing diadrams and locations of the components all u need to fix any thing on u bike .....my 82 honda saber had lots of electrical prob's & lighting prob,s i bought the service manual and fixed every thing... saved me hundreds o $$$$$$$$$$$$
let me know
SOURCE: BRAKE LITES WON"T WORK
you have a corroded ground in the back light bar..remove the rear light bar from the fender and make sure it is clean, not rusty.
SOURCE: Replaced bars on my 1994 Intruder 1400....now it won't start?!?!?
commen thing with bikes when disturbing the wiring loom !
it may have a loose or dirty connector
someitmes its a break inside the wiring when that you wont see!
check the grounding & ignition curcuits
SOURCE: Rear tail light does not turn on.1998 suzuki 1500 intruder
It mught be the bulb that needs replacing or else check the wiring to the bulb for continuity in case there is a broken or snapped bit.If you have a voltmeter then you can test the voltage reading at the point of contact..Sometimes rust builds up and a simple cleaning would solve this.Hope this helps.
392 views
Usually answered in minutes!
×