At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
The E100 is a Kick Start scooter, the Rear Wheel has to be Spun for it to start. This scooter will not start from a motionless position.
Could be the battery.
Put the Scooter on a block so the rear tire is raised. Remove the standing plate to reveal the battery compartment.
Charge the Unit completely
1. Using a multimeter measure the voltage across the batteries. If the voltage is below 20 volts batteries are dead - Replace batteries.
2. Now for a running test. Turn the throttle and spin the rear tire to preform a kick start. Still measuring the voltage. If the voltage is Below 20 volts or if the voltage drops quickly batteries are dead - Replace batteries.
3. If the voltage is remaining around 24 volts for a long period - then you could have connector problems, clean and tighten all connectors.
I use a fiberglass electronic cleaning brush, as contact cleaners leave residue that interfere with electrical connections.
ok when ever you replace the batteries on Pride Equip you must condition them for the first week 8-14 hours charge every night unplug every morning and after that charge as needed not every day unless it is absolutely needed. If you did not do this then you could've ruined the batteries.
razor hasnt been charged for a week as i needed a new charger i had 1 scooter charging over night yet still nothing , i bought a new charger its showing green on the light do i have to wait till it shows red and then wot if it doesnt still work
Bad connections on the battery posts is most likely. If the circuit breaker was bad you'd get nothing at the battery . The charger voltage is 29 volts when not connected to the batteries. 26 or more when connected and on.
It is definitely frustrating when you can't get your scooter or moped started. The first thing you'll need to do is to narrow down the problem. In order for your gas scooter to start, it really only needs 3 things:
1. Your scooter needs to spark at the correct time. 2. Your engine needs the proper fuel/air mixture and exhaust flow. 3. You need sufficient engine compression.
Top 9 Reasons Why Your Scooter Won't Start:
1. Try depressing the brake handle when starting. 2. The battery has not been charged. 3. The battery is hooked up wrong. This is often the reason for blown fuses. 4. There isn't enough gas or two-stroke oil in the scooter. 5. There is a gas flow problem, especially on the Euro Scooter or Yamaha models. 6. The spark plug wire is not connected. 7. A low battery or bad relay can cause the scooter to only start by using the kick starter. 8. There is no spark to the spark plug. The coil is bad and needs to be replaced. 9. Turn the key to the "on" position.
×