Head bolt torque specs does anyone know what it is?
SOURCE: 91 kx 250 torque values
Engine Top End:
Auto Decompressor Bolt 104 in·lb
Cylinder Head Cover Bolts 87 in·lb
Cylinder Head Bolts: M10 36 S
M6 104 in·lb S
the S in that means the specified pattern ... just like tightening car tire bolts... please note all that it its INCH lbs....
don't know why it says just 36 for the M10 bolts unless they left out inch lbs
Anything else let me know as i've got a manual for the 250 f... actually i've got a few different ones
Robert
Please take a moment to rate this solution as i've taken a few minutes to find the manual thanks
SOURCE: what is the head bolt torque spec for a kawasaki
28 nm buddy make sure you tighten them down evenly like opposite to opposite
SOURCE: torque spec for 2000 kx250 head bolts
Head nuts 18 ft-lb (25Nm), cylinder base nuts 25 ft-lb(34Nm)
SOURCE: what is the torque setting
Cylinder Head Bolt Installation Cylinder Head Bolt Installation
Factory
Method
For each cylinder head, start with head bolt numbered one.
In increasing number sequence (1-2-3-4), tighten the head bolt in three
stages.
1. Tighten each bolt to 7-9 foot pounds of
torque.
2, Tighten each bolt to 12-14 foot pounds of
torque.
3. Mark each head bolt and head with aligning marks. Tighten
each bolt 1/4 turn (90 degrees).
Torque
Wrench Method
For each cylinder head, start with head bolt numbered one.
In increasing number sequence (1-2-3-4), tighten the head bolt in four
stages.
1. Tighten each bolt to 7-9 foot pounds of
torque.
2. Tighten each bolt to 12-15 foot pounds of
torque.
3, Tighten each bolt to 22-25 foot pounds of
torque.
4, Tighten each bolt to 38-42 foot pounds of torque
Good luck, i hope this helps.
SOURCE: no problem I need torque
caliper torque 28-38 ft lbs,front axle nut torque60-65 ft lbs. front brake rotor torque 16-24 ft lbs. straight from harley manuel.
374 views
Usually answered in minutes!
×