Repair kit for fok telescope problems

Replace the Fork oil seals. It will require you to support the bike from the headstock and remove the forks. You will also need to know the correct amount of fork oil to put in each leg. Buy the manual for your bike (whatever it is) it will cost about 20GBP. a new set of forks will cost considerably more.

Check with the dealers parts dept,should be
May have to buy more than just the seal
Check the internet sites for the seal

Gaiters, I can assume you are referring to the rubber telescopic spring covers on each fork. There is only one way to change these I'm afraid and that means the forks have to come off the bike and come apart on the bench.Triumph never did anything easy! Take the oppurtunity to clean the forks,replace the oil seals and change the fork oil and inspect all the bits.(might as well) When installing the new gaiters the info I have says to use a light oil to help slip them into place by hand with an even pressure.No screwdrivers or pliers. Hope this has helped,nice to chat with another British fan,good luck with the job.Cheers

The forks need to come apart.
I highly recommend getting the factory service and repair manual.
You will need a seal driver tool, and measure the correct amount of fork oil. This isn't a simple job, and it's why I recommend the book.

remove the front wheel and the brake caliper unscrew the tops on both forks just losen them then losen the clamp bolts knock the foks out with a hammer unscrew the tops on forks tip the forks upsidwe down into a jug compressing at the same time onece all drain see how much oil is init and refill with the same amount as in the jug compressing the forks up and down as you fill it up and then refitt it the same way

fork oil type -fork oil#10, oil capacity each leg 388 ml for E-01,28 33 models and 392 ml for the other models standard oil level 142mm for E-01,03,28,33 138mm for the other models

you should put in new fork seals before adding oil -leaking fork seals should be repaired as oil can get on the front brake pads--buy a clymer manual and you can change them yourself

you can buy a repair kit @ any local parts store or a "Pan saver"

Not worth repairing-- a new focuser for your telescope would cost as much or more than the telescope-- unless you can find a discarded telescope of the same model..... for parts.