Torque specs
As tight as you c an get the bolts by hand will do maybe 30 -40 pounds.
Hi, When torque is desired the size of the bolt, thread and materials is all that is needed except on heads. When tightening head bolts it is important to follow manufacturers specifications. Other fastener specs may be found here; http://raskcycle.com/techtip/webdoc14.html
SOURCE: Front Hub Bearing Torque specs to complete replacement
THE LUG NUT TORQUE SPEC - 140FT/LBS\
CALIPER MOUNT - 80FT/LBS
CALIPER BRACKET 129FT/LBS
AXLE NUT 177FT/LBS
SOURCE: head bolt torque spec
Always use new head bolts.
1)tighten to 40ft/lbs
2)back off 1/2 turn
3)tighten back to 40ft/lbs
4)tighten an additional 90 degrees
5)tighten an additional 90 degrees.
SOURCE: head bolt torque specs for 2000 dodge neon 2.0 SOHC
I have the specs and diagrams. If you want me to send them to you, give me your email address. [email protected]
SOURCE: 94 mazda B3000 3.0L cylinder head torque specs
Step 1 torque to 59 ft pounds
2. Loosen one full turn
3. 37 ft pounds
4. 68 ft pounds
Use torque sequence below
SOURCE: torque specs on replacing cv axle on 05 Pacifica
ok here we go tie rod=55 ft lbs axel nut= 180 ft lbs strut bolts= 65 ft lbs plus 90 degrees
Testimonial: "thank you very much!!!!!!!!!!"
1,116 views
Usually answered in minutes!
×