Question about 2007 Kymco People 150
Seems like no spark. Put thick copper wire into spark plug wire and held it about 1/16" away from the frame. Did not see any spark. Sprayed starter fluid into the carburetor and tried to start, just turns over. Had to recharge battery three times as I try different things. Tested spark plug wire and it measured .5 ohm. Tested the inputs to the coil was 8.4K Ohm. Put a voltmeter across the inputs to the coil and on all scales ac or dc, the voltmeter never flinched as I tried to start it. @
Hi, Info40176 and the usual suspects are:
1. Fouled spark plugs.
2. Severely discharged or a damaged battery should have 12.5 volts or more and be able to pass a proper "LOAD" test if necessary, you may have a preliminary reading of 12.5 volts or more but little or zero amperage the battery is faulty and must be replaced, AGM batteries fail in this scenario more so than lead-acid batteries.
3. Check battery terminals for damage or corrosion, check the battery cables at "BOTH" ends for loose, corroded, or broken connectors, "INSIDE" and outside the cable harness, perform connector wiggle test and check cables with an ohmmeter if necessary.
4. Loose connection at ignition coil or plug between ignition sensor and module.
5. Spark plug cables in bad condition, shorting/leaking, spark plug cable connections loose check for spark leakage in the dark.
6. A faulty ignition coil or electronic control module.
7. Faulty pulse coil.
8. Faulty CKP, CMP, or BAS sensor.
9. Faulty ignition switch.
10. Faulty run/off switch
11. Tilt sensor needs a reset.
12. Security alarm failing to disarm needs reset
For more information about your issue and valuable "FREE" downloads that you will need for viewing or printing please click on the blue links below. Good luck and have a wonderful day.
GY6 Electrical Troubleshooting Tutorial No Spark Eliminator
Kymco Scooter Parts ATVs Scooter Parts Performance Scooter Parts...
Posted on Jul 13, 2019
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
get a can of starter fluid and spray a short burst into the air intake...it should fire up...if it won't stay running or idle your carb is clogged from storage i presume...right? usually storage for more than 3 mos will clog a carb if you did not winterize it...Good luck to you friend...Tim
Posted on May 11, 2009
The starter relay needs replaced. If you follow the + wire from the battery, it goes into a box with a + wire on the other side of it. If you jump power across the two wires, it should start
Posted on Jul 30, 2009
Tips for a great answer:
Aug 31, 2017 | Tank Motorcycles
Jun 19, 2015 | Kymco Motorcycles
Nov 24, 2013 | Clear Ranger Heavy DutyTM Windshield 95-97...
Apr 18, 2013 | 2007 Kymco Bet and Win 150
Jul 13, 2017 | 2007 Kymco Bet and Win 150
Jul 21, 2011 | 2007 Kymco Agility 50
Aug 17, 2017 | Kymco Ninja 500R Motorcycles
May 17, 2011 | 2005 Kymco Vitality 2T 50
Dec 13, 2019 | Yamaha Motorcycles
153 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: