Question about 2004 Yamaha PW 50

1 Answer

How do you check the oil level on a 2004 Yamaha PW 50

Blue and white color @

Posted by Anonymous on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    One Above All:

    The expert with highest point at the last day of the past 12 weeks.

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

  • Yamaha Master
  • 59,350 Answers

Hi, Anonymous if you are experiencing excessive oil coming out of the crankcase breather or air filter please drain all engine oil and replace half of the same oil that comes out. Many riders are overfilling their oil system because they do not know how to properly read their oil site glass or dipstick. The following procedure works on nearly all 4 stroke engines but to be on the safe side you should refer to your owners manual. Use your center stand if you have one.
1. Bring the engine up to operating temperature or let idle for 5 minutes.
2. Turn off your engine and let it sit for 2 minutes, this will allow the oil from the top end to drain to the bottom.
3. Hold your bike straight up or on the center stand and wait 2 minutes for the oil in the bottom of the engine to be level in the sight glass or on the dipstick.
4. Your oil level should be between the top full mark and the bottom add oil mark.
5. Never overfill your oil system it will cause problems:
a. oil leaking out of exhaust pipes.
b. oil leaking out of breather pipe/hose.
c. oil carryover into the air cleaner.
6. Your oil site glass must "NEVER" be completely full or empty drain or add oil as necessary.
7. Your oil dipstick must "NEVER" be over the full mark and should never be below the add mark drain or add oil as needed.
For more information about your issue and valuable "FREE" downloads that you will need for viewing or printing please click on the blue links below. Good luck and have a wonderful day.
PW50 Oil check
Trans Oil Level PW50 Forum
2000 2005 Yamaha PW50 Service Manuals Collection Download Manuals Technical $15
https://www.partsfish.com/page/oem-parts-for-yamaha
Yamaha PW50 Owner Manual

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/gregg_c0ec1df182c7330e

Posted on Dec 11, 2017

Ad

5 Suggested Answers

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Anonymous

  • 8 Answers

SOURCE: How do I check the oil level and add oil to an 83

look down low on the right side of the engine, their is a "sight glass" that you will be able to see the oil level, tilt the bike a bit and you can see the oil, leave the bike on the regular kick stand and if you can see the oil in the glass the level is fine, above that is the oil fill cap, that is where you put the oil, i think your bike holds 2500 cm of oil, that is about 2 and 2/3 quarts of oil. remember that motorcycle oil is different than regular car oil, this is a common mistake which also leads to the clutch plates sticking together after a bike sits a while.

Posted on Jul 05, 2009

Anonymous

  • 1 Answer

SOURCE: How to check my oil level on 04 Yamaha yzf 600

YZF600R is a carbureted model. OIL: The oil sight glass is a round window, low on the right side. Very hard to try to see when astride the bike, even if you use a mirror on an extension rod. Have a friend hold the bike level,perhaps, while you check. Oil should be sighted after the bike has been sitting for a time after riding. I suggest using a good 10W-40 regular motorcycle oil (Least expensive around here in Boston is to buy Kawasaki by the gallon at Riverside) I found the pesky 1st-to-2nd shift to be more direct with this oil than with synthetic. I had plenty of opportunity to compare the two types. GAS: No reserve, but as noted, there is a low fuel light, in the row of lights that includes the neutral light and the high beam indicator. You ought to be getting over 50 m.p.g., so you can estimate your 'range' from that. I usually fill up again around the 180 mile period. I think I've seen the low fuel light once in 6 years of ownership. OH: I suggest you treat the gas, on a regular basis, with 'marine' Stabil, not the regular stuff. I have had a 'gummy' Yamaha Virago 250 to care for, that I thought would never clear its fuel problems. Last winter ('08-'09) stored it with the marine Stabil in the tank and run for a while to get it into the carbs also. Within a few minutes of running it this spring-actually a couple weeks ago- it smoothed out and has run fine since. I believe this HAS to be as a result of the treatment of the fuel (run through the carbs before the winter storage) with this special Stabil. It was recommended by Carlo at Riverside- I'll have to remember to thank him for the advice. N.B. I always change the fuel (siphon it out, put that Stabil'ed but 'old' stuff into my car tank, refill the bikes with fresh 93 octane) each Spring.

Posted on Aug 17, 2009

ckoira57

ckoira57

  • 267 Answers

SOURCE: i have a yamaha pw50, it runs slow when cold &

Most likely a combination of sparkplug heat range (type of plug) and jetting, needle or air mixture settings in the carburetor. Assuming good condition of air filter and operation of the choke plunger. Are you using the correct octane fuel and fuel/oil ratio? Give the plug a clean and emery the spark contacts, set gap at 0.7mm., ideally take the plug to a Yammy dealer and check for correct range for your bike in the area where you ride.
Best to have a range of spare clean plugs handy for wet or hot days etc.
The jetting maybe dirty or wrong size too. In the meantime move the throttle needle clip down one notch. Refer to the site below for a diagram of the carburetor parts. Cheers.
http://www.cmsnl.com/yamaha-pw50r-2003_model11163/partslist/A-09.html

Posted on May 11, 2010

Curtis Shaw

  • 71 Answers

SOURCE: 1995 Yamaha TY250z

there is a screw on the side of your clutch cover that is your oil level screw. dont even use it as its not reliable... beside the oil fill hole it will say how much oil goes in. on my 03 yz 125 it takes 650cc yours will tell you. Drain your oil and put how much it says in. I use rotella t oil from walmart its in a white quart jug. Its the same oil the pros use and its cheap as well. dont go spend a fortune on "good" oil when rotella t is just as good.

Posted on Jul 12, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Cat 5 cable


The normal color code is. Orange white, orange, green white, blue, blue white, green, gray white, gray. the wire using for network only 2 pair. That is 1,2,3,6. For normal telephone - use blue pair (4,5). For pabx system use. 3,4,5,6. Connection. You can use any Color code If both ends are same.

Jul 02, 2012 | Computers & Internet

1 Answer

Wall Plate teminals have the colors of Green, Red, Black, Yellow, White, Blue, Brown and Tan. Cable has the Colors White/Blue, Blue/White, White/Orange, Orange/White, White/Green, Green/White,...


see the table on this link:

http://www.server-servers.com/ge-cat5-network-wall-plate-straight-through-cable-setup/

GE Network Wall Plate Cat5 Ethernet Cable 1 Blue 2 Orange 3 Black 4 Red 5 Green 6 Yellow 7 Brown 8 White White / Orange Orange White / Green Blue White / Blue Green White / Brown Brown
GE Network Wall Plate Cat5 Ethernet Cable 1 Blue 2 Orange 3 Black 4 Red 5 Green 6 Yellow 7 Brown 8 White White / Orange Orange White / Green Blue White / Blue Green White / Brown Brown

If I could be of further assistance, let me know. If this helps or solves the issue, please rate it and give a testimonial for my response

Thanks, Joe

I’m happy to assist further over the phone at https://www.6ya.com/expert/joe_8b8c2cd6ce148309

Apr 15, 2011 | Computers & Internet

2 Answers

I have a cat5e wall plate(tph552) a cat5e wire4 colors don't match and 4 colors do ( brown,orange,blue,green,) are ok then wire has 4 that are white with (brown,orange,green,blue,)stripe. and wall plate...


The wires/colors in a category 5e cable run in pairs. They should be tightly twisted together, mostly white with a blue tracer. mostly blue with a white tracer- mostly white with an orange tracer- mostly orange with a white tracer, mostly white with a green tracer- mostly green with a whte tracer, and mostly white with a brown tracer- mostly brown with a white tracer.The jack you have sounds like a standard telephone or cat. 3 jack. If the jack is being used for a standard telephone line, you'll need to connect one of the wire pairs(usually the white/blue pair) to the green and red terminals on the jack.Make sure that the same pair is also terminated at the main telephone junction.

Aug 08, 2010 | RCA Computers & Internet

1 Answer

Need color code for radio harness


Hello Mexicano1037,

Here are the colors for the radio harness on your '91 Escort.

1991 Ford Escort Radio Color Codes

Battery Constant 12v+ Wire: Blue/Red
Accessory Switched 12v+ Wire: Blue/Black
Ground Wire: Black
Illumination Wire: Red/Black
Left Front Speaker (+): Violet
Left Front Speaker (-): Blue/Orange
Right Front Speaker(+): Blue/White
Right Front Speaker(-): White
Left Rear Speaker (+): White/Blue
Left Rear Speaker (-): Red/Blue
Right Rear Speaker (+): White/Green
Right Rear Speaker (-): Blue

Hope this helps.

Apr 12, 2009 | Car Audio & Video

2 Answers

Wiring on a RCA RJ-45 wall jack


the RJ45 wallplate is not meant for ethernet. It's an 8P8C connector for a phone. Will it work as a network jack? Maybe. I wouldn't use it, but if you really want to try, wire it thusly:

1 Blue --- Orange/White
2 Orange --- Orange
3 Black --- Green/White
4 Red --- Blue
5 Green --- Blue/White
6 Yellow --- Green
7 Brown --- Brown/White
8 White --- Brown

I'd still recommend a CAT5 wallplate with a CAT5 jack.

Apr 11, 2009 | Computers & Internet

1 Answer

White colors schemes seem off white color or brownish color and blue has green tint or baby blue color. .


Check the coolant in all three crt's as chances are it is contaminated (should be crystal clear). If brown (beer color), replace coolant in all three crt's and perform convergence adjust. Picture should be like new!!!

Good Luck!!!

Jul 20, 2008 | Akai PT5598HD 55" Rear Projection...

1 Answer

Ethernet cable


568-B Wiring
Pair Wires RJ-45 pins
1-White/Blue White/Blue 5
Blue/White 4
2-Wht./Orange White/Orange 1
Orange White 2
3-White/Green White/Green 3
Green/White 6
4-White/Brown White/Brown 7
Brown/White 8
568-A Wiring
1-White/Blue White/Blue 5
Blue/White 4
2-White/Green White/Green 1
Green/White 2
3-White/Orange White/Orange 3
Orange/White 6
4-White/Brown White/Brown 7
Brown/White 8
RJ-45 Pins are with the spring tab down and read left to right. Do you have an RJ-45 Crimping tool?
Just use 568-B or 568-A on both ends of the same cable.

Jul 05, 2008 | Computers & Internet

1 Answer

Cat 5 Issue you replied to


The color is not so important as the cable follow the same standard on both ends.
It has been my misfortune to find non-standard wiring in a facility, so long as they keep the relationship of the pins the same it will work, if the installer did not then you cannot trust any of the work and MUST either redo it all or have it all tested and certified by a cometent network cable installer.
568-B Wiring
Pair Wires RJ-45 pins
1-White/Blue White/Blue 5
Blue/White 4
2-Wht./Orange White/Orange 1
Orange White 2
3-White/Green White/Green 3
Green/White 6
4-White/Brown White/Brown 7
Brown/White 8
568-A Wiring
1-White/Blue White/Blue 5
Blue/White 4
2-White/Green White/Green 1
Green/White 2
3-White/Orange White/Orange 3
Orange/White 6
4-White/Brown White/Brown 7
Brown/White 8
RJ-45 Pins are with the spring tab down and read left to right. Do you have an RJ-45 Crimping tool?

Apr 21, 2008 | Computers & Internet

Not finding what you are looking for?
2004 Yamaha PW 50 Logo

Related Topics:

589 people viewed this question

Ask a Question

Usually answered in minutes!

Top Yamaha Experts

vince

Level 3 Expert

1234 Answers

Steve Sweetleaf
Steve Sweetleaf

Level 3 Expert

1176 Answers

Israel Pineiro Jr

Level 2 Expert

165 Answers

Are you a Yamaha Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...