Hi Fixya Team, It is a Kymco Brand D*nk 250 Scooter, year 2005. The speedo os cable drove from the front wheel. Obviously it plugs into the console from the bottom. I cannot get in there. I

SOURCE: Instrument panel bulb removal

Push the rubber boot forward from behind and the bulb glass cover should pop out from the front of the instrument panel with a little prying with your finger tip. You don't have to push it far, just enough for the cover to pop out of the lip. Then you will be able to remove the bulb. I then use needle nose pliers to remove the bulb.

SOURCE: SPEEDO CABLE BROKEN IN SPEEDO DRIVE HOUSING CBR 125 R 05

take out the front wheel remove the drive it should tap out with a bit of gentle tapping they are not that tight fitting

SOURCE: My son's 2005 Kymco TGB 50cc scotter hit a good

Normally, one goes to the carb, one to the gearbox and one to the battery. What sounds really weird is the diameter of the hoses. Three quarter and one inch diameter? Normally 1/4" to 3/8".
Hope this helps!

Please rate this solution. Thanks locjaw69!

SOURCE: 1985 honda v65 sabre has speedo needle stuck on 35

Check for bad fuse holder spring contacts. Loss of power to speedo or sensor will cause this problem as V65 Sabre uses stepper motor for speedo.

SOURCE: how to remove front fairing 250 kawasaki ninja

there are small allen bolts or lock screws.. take them out and it should just come off