How do you change the starter on a 2008 street glide with stock headers?
To remove a 2008 touring starter FIRST remove the seat disconnect and remove the battery negative cable (black) from battery negative (-) terminal, remove the starter front and rear mounting screws with captive washers, remove the Keps nut from the stud of the bracket tab and remove the exhaust support bracket, pull back the rubber boot and remove the hex nut from the battery Post, remove the battery positive and the main power cable ring terminals, remove the starter solenoid connector at the front of the starter, remove the engine oil filler cap/dipstick and cover the fill spout opening with a clean shop cloth or towel to keep out foreign objects/material, to facilitate starter removal, if necessary, remove the two worm drive clamps to release the heat shield from the rear header pipe, remove the starter from the motorcycle carefully sliding it out through the space between the rear exhaust header pipe and the side cover exercising caution to avoid losing the two ring dowels that are somewhat loosely installed in the primary chaincase (or starter) flange.
To install a 2008 touring starter FIRST verify that the two ring dowels are installed in the primary chaincase (or starter) flange, lubricate the o-ring on the starter and lubricate the bore of the primary chaincase with a light film of clean primary chaincase lubricant, carefully slide the starter in through the space between the rear exhaust header pipe and the side cover and with the starter solenoid connector at the front, move the starter into its installed position, remove the shop cloth or towel covering the oil fill spout and install the engine oil filler cap/dipstick at the top of the transmission case, install the slot of the exhaust support bracket onto the stud of the bracket tab aligning the other holes with those in the starter flange, start the Keps nut onto the stud, engage the hole in the exhaust support bracket, install the starter front mounting screw with captive washer, install the starter rear mounting screw with its captive washer and alternatively tighten the starter front and rear mounting screws to 25-27 ft-lbs (33.9-36.6 Nm), tighten the Keps nut on the stud of the bracket tab to 12-15 ft lbs(16.3-20.3 Nm), install the main power and battery positive cable ring terminals onto the battery positive post, install the hex nut and tighten it to 70-90 inlbs(7.9-10.2 Nm), pull down the rubber boot over the terminal connections, install the starter solenoid connector at the front of the starter, if removed, install the three worm drive clamps to secure the heat shield to rear header pipe, tighten the clamp screws to 20-40 inlbs(2.3-4.5 Nm), insert the bolt through the battery negative cable (black) into the threaded hole of the battery negative (-) terminal and tighten the bolt to 60-96 in-lbs (6.8-10.9 Nm) and reinstall the seat.
×