Hi, my 2007 sm 510 r's front and rear and stop lights stopped working a few days ago and now i am not getting a spark, no power is getting to the coil, can you help? Regards, Lee.

good set of facts,
all else works car drives day and night, head lamps work.

im reading the cars SM schematic now.
there are other fuses marked brake for brake failures not rear 3 lamps, so I call wrong fuse.
the path is.
under hood fuse box STOP LP fuse good
stops switch at pedal 12vdc one side then 12vdc both sides
pedal down.
the fuse VEH-STOP in IP fusebox.
then wires to lamps 3.and G401

one more, fuse
for tailer and center lamp CHMSL truck
IP box. VEH CHMSL fuse.
but under hood fuse must be good.

I would check the spark plugs and wires or coil packs. Sounds like the ignition system is arcing.

Please Use WRITEX CD/DVD Lenses Cleaner to clean your CD/DVD Drive then check it.

Hi,
check if the stop light switch is working on the front brake lever /rear break pedal.It could have failed and not sending the command to the stop light to go on

my driverside headlight stopped working, the bright will work but not the dim. fuses and power was good, do you think it could be same solution to my prob?

Hi,
There could be loose memory modules in the system. Cause the diagnostic lights that you are getting suggest loose memory modules. You can follow the link below to reseat the same .
http://support.dell.com/support/edocs/systems/dim5150/en/sm/parts1.htm#wp1364711


Thanks for using Fixya
Proton

Check the power supply & fuse.

Do not remove the rubber from your spark plug wires. This is the only thing insulating it from the bike. If you are not getting spark, check for power at the coil, check the pickup, then the CDI box.

Here are some suggestions:
1. Faulty Fuse.
2. Spray WD-40 on the contact switches.
3. Re-insert the fuses.
4. If you say that the two filaments light up when you hit the brakes, try turning the lights on. The rear taillight should light up.

Hope this helps