SOURCE: 1998 GT shifts in all gears except 4th
if it is shifting fine through all gears but fourth then it is probably a syncronizer
SOURCE: New clutch cable made gear change much worse.
Hi,
Had a recent similar problem. Fortunately, my replacement cable is adjustable. As the new cable stretched, I had to take a crowbar to the the throwout lever next to the battery and lever it back while pulling off the cable (towards the battery). I then lifted the fuse box (look out for the 10mm plastic nut that holds it in on the side by the driver's side fender) on the drivers side right in front of the windshield to reach down and pull the cable up enough to reach the adjustor. When it is high enough, release the locknut and turn the adjusting nut upwards about 4 turns (both nuts on my cable were 17mm and a "stubby" is handy but not necessary. Grab the end by the battery and, making sure it is seated on the groove on the transmission, pry the lever again with the crowbar and reseat tg
he cable end in the lever. I have had to readjust the cable twice more before it settled in a comfortableplace, but once you get the hang of it, it only takes about 10 minutes.
Hope this is helpful.
SOURCE: replaced clutch in 3000GT, all new parts, plate,
Are you sure the clutch disc is installed in the correct direction?
Admittedly, I haven't seen the clutch disc for a Mitsubishi 3000GT, but I have seen my share in many makes of vehicles.
The clutch disc may be one of those that will install in either direction. Some clutch discs are made so that the inner hub with springs, can be installed towards the crankshaft, or towards the tranny.
SOURCE: clutch wont allow me to shift gears while driving
pump the blank out of it....i have had to pump one of these new clutchs 100or more times to get it to bleed right...and yes i am saying just sit there and pump the clutch so what do you have to loose besides a couple of pounds....have a happy new year
31 views
Usually answered in minutes!
×