What is the engine management and injection fault indicator light

I am not familiar with the car model in question but you may find that the engine management light is on on the dash display. This may indicate an electronic fault. The management program may have switched to "Get you home" mode. Check your dash lights and cross refer with your owners book.

Take the car back to the dealer, or if you can get someone to do a scan for fault codes too, that could send you I the right direction. Aske the dealer if there are any ignition switch harness recalls.

This is the emissions system warning light, commonly referred to as the "Check Engine" light.
Please read on.

The information below was complied by me, it explains what causes the check engine light to come on and the process of finding the cause.

When the Check Engine light (or Service Engine Soon) is turned on, the systems computer control unit (called the ECM) has sensed a fault in the electronic controls of the engine and/or the emission system. When this happens you will seldom feel the car engine run any different. There are about 50 possible system faults. To find out which one is causing a problem have the system scanned by a local shop with a MB compatible scan tool.

this engine heater glow indicator .this indicate if you have water with diesel inside the injection pump or if you have problem with brake light S.W can be check if rear light is ok on /off with brake and in this case engine will not cuts off .check fuel replace fuel filter if you can find injector cleaner is good to clean injection pump and lubricate to avoid injection pump noise and low pressure

You have a fault condition in the the engine management system - get the codes read to indicate where the fault lies ... It is probably just a faulty sensor as this is the most common cause of check engine warnings. The restricted performance condition is meant to protect the engine or components from damage, so don't panic - get the codes read - its probably not as bad as you expect. hope this helps - good luck.

Probably the check engine light or service engine soon light, indicating a fault code has occurred shutting down the engine. Recommend you get it scanned at a large parts retailer or dealership to better diagnose the trouble code. There are hundreds of different codes and hundreds of different causes for a stalled engine.

It indicates that the vehicle's computer has recorded a code in the memory. It will be a malfunction code of some sort. A code reader tool is connected to the diagnostic connector under the dash to retrieve the code, which gives information as to which engine management system has experienced a malfunction.

where is the connector located?, i have a 1995 Aston DB7 and i have the engine management light on?

how I know the timing wear on my piaggio 180 four stroke scooter ?

this is the engine management system warning light indicating a fault,it may not be serious as this light covers hundreds of faults.Take it to a garage and they will plug a computer into your car and find the fault.Dont panic just yet,it could be an easy fix.Hope this helps.