SOURCE: 1996 zx11 getting sprk to one bank only
Hi and welcome to FixYa,
The voltage on the green wire must be pulsating when cranking/starting the bike, not steady. Confirm by similarly testing the voltage on the black wire on the left ignition coil. If the green still reads a constant voltage, then the CDI is faulty; to be more specific, most likely that the switching tansistor inside the CDI that drives the right ignition coil has shorted.
Good luck and thank you for asking FixYa.
SOURCE: 1983 yamaha xj 650 no spark already changed the
SOURCE: no spark put on a new cdi box coil good and a new
hi,sounds to me like your cdi pickup unit has failed,i am not 100% certain but this will be located on the end of the crankshaft behind one of the enginecovers,there could be two other possibilities,motox bikes are notorious for breaking wires so check the wiring from the cdi sender unit to the cdi box and the coil,also check your "off"button it may be stuck in the "kill" position..hope this helps..cheers ian
SOURCE: hi i have a 1997 yamaha 350 warrior i have no
hello, you probably need to have your stator checked out, sometimes the pickup coil in the stator will go out, also you can try ign coil, the one spark plug wire is hooked to,warriors are bad about cdi going out, mine would idle, would not rev up, would bog down, source coil in stator probably needs to be checked also..
SOURCE: will 1989 yamaha 350 warrior cdi box match up with
i have a 89 350 warrior and i was wondering if i could adapt a 90 style cdi box to my 89
1,687 views
Usually answered in minutes!
×