Need 10th UNDERSIZE bigend and main bearings.2.2 HDi 120 130BHP 333

general motors, 1.2L engine.
main bearing, 22 ft lbs plus 30 degree turn.
rod bearing, 15 ft lbs plus 90 degree turn.

hi lourens.
not sure if this link will help but have a look.
do not go into anything that has the word fixya next to it as it will only bring you back here.
torque settings on 2 2 ford ranger tdci 2012 head bolts mains and big end...

Hi again i found this info on rod & crank clearance 5.9 Cummings .002 to .004 U can always check clearance with plastiguage just to make sure hope this helps GOOD LUCK. only thing i could find was bigend side clearance min .004 max .013in crankshaft end clearance min .004 max.017. ,TRY RINGING CUMMINGS 03 9765 3222 or 03 9360 0800. Good luck....Cummings 6B, 6BT, 6BTA Main Bearing bolts 176 Nm, 130 lb.ft. Con rod 102 Nm, 74 lb.ft. Cylinder head bolts 126 Nm 93 lb.ft ...... Cheers

https://www.google.com/?gws_rd=ssl#q=Torque+settings+for+main+%26+bigend+bearings+on+bmw+e30+318i+m40+engine

Hope this helps

I would call your local part store, they should have a listing for oversized bearings.

go on line -typr in torque specifications for toyota 1jz engine and there will be a pdf spec sheet of all the vehicle torque settings.

WHAT IS THE SETTINGS OF MAINS AND BIGENDS ON A CHANA 1100

v6 have 4 main bearing sets and 6 big end bearing sets
v8 have 5 main bearing sets and 8 bigend sets
5 cylinder inline will have 6 main bearing sets and 5 big end set
It appears that some where you are short a set of bearings Check that the rebuild kit is for your engine

hi mark.
this is all i could find.
go to this link but do not go into anything that has the word fixya next to it.
Main bearing torque settings ford 2 2 hdi Google Search

If the bearings need replacing the crankshaft will need grinding. After the crank has been ground you will have to buy suitable main and conrod bearings EG: 10thou undersize.
After fitting new bearings to the reground crank no adjustment is necessary.