Riding and heard a loud pop. Quit.Main fuse had hole burnt through it. No spark. Wondering what common, coil or cdi unit. Thanks
SOURCE: 2005 ktm 450 sx die while riding.
yes, you are correct, those are the two pieces that could solve your problem, but i would go first for your cdi, you may choose to have it tested first also, before you jump out to buy a new one.
SOURCE: no spark 110cc engine wont start
Check the fuses. Next, check for spark but with a new spark plug. How good is the battery? If needed, add water to the battery cells enough to cover the top of the cell plates.Try a jump start from your car battery. Is the kill switch on? Check the operation of the ignition switch with a volt ohmmeter. You should be getting power into and out of the ignition switch.
If the bike doesn't start and run properly check the side stand kill switch. It kills the engine so that you don’t start out with the side stand down. Broken or out of adjustment, it would kill the spark. Check for a broken wire at the switch or coupler. Get a service manual and check out the electrical section. Some bikes have a diode integrated into the turn signal relay. Try moving the kill switch by hand. If that doesn’t work then wire a jumper around the switch to bypass it. If that doesn’t work, check out the relay.
Check the wiring harness. Did a wire come unplugged? Are all wires clean and with solid connections? Any abraded or pinched wires? Is the bike in neutral and the neutral light is lit up? If no neutral light, check the neutral switch and neutral switch wire on center casing.
Please rate this answer. Thanks
SOURCE: briggs & stratton 190707 wiring diagram
make sure your coil has not move ajust to 010. gap check magent on flywheel.see if strong.if all is ok yes coil is bad
SOURCE: yz125 no spark
G'day i am a . YZ 125 j ...lets see now! You could perform these tests yourself.Check your plug CAP,if in doubt replace it with a new one. Take the below ohm figures and see if they match up. Pulse coil: white/blue and white/red= 310 ohms. low speed coil: Green/white and Black/red= 900 ohms. high speed coil: Green/blue and black= 55 ohms. hope this has helped in some way to helping you solve your problem.If it has please leave feed back.Ride hard , see ya,Tabbycat
SOURCE: 1999 Polaris 500 ATV: Battery went shot. Just use
I had a simular problem with my 99 sportsman 500 and it turned out to be my pulse coil somehow became out of alinement. The pulse coil air gap should be between0.016 to 0.040 inch, But I would start by checking the coil it should read 0.3 to 0.5 ohms. Good luck and hope this helps
437 views
Usually answered in minutes!
×