Engine *gv48318186*
SOURCE: 1998 harley davidson softail custom primary cover bolt pattern
Are u asking for the torque sequence for the outer primary cover ?
SOURCE: what type of motor oil used in 1994 harley davidson 883
harley recomends that you use their oil but i would be carefull because it is a cynthetic now if you were using regular oil what that will do is clean all the old build up out of the motor this can be bad because after time there are pin hole leaks that occure but the build up stops it from leaking but if you use cynthetic you cant go back to regular oil it will gum up on you and ruen your motor so you got to find out what has been put in it. but use a 10-30
SOURCE: removing harley davidson ultra classic gas tank
Drain the fuel either by siphening or removing the cross over tube at the front of the tank and letting it drain that way or just block off those cross over lines and leave the fule in the tank for removal.
0) remove seat
1) drain fuel
2) undo cross over line (bottom front of gas tank.
3) shut off pet **** and remove fuel line from pet ****.
4)there should only be 2 bolts holding the tank on, one at the top front of the tank and one at the back of the tank.
All in all a pretty easy (but possibloy messy) job.
SOURCE: what size spark plug for a 2000 harley davidson road king carbed,
Your Twin Cam plug should be a 6R 12 Harley Plug. Often times the back fire is just the nature of the beast depending on what type of pipes you are running. Harleys do run lean, its an EPA thing thtas why they choke them down from the factory. Since you have a carb you could have an intake leak around the Intake. Also Under the carb is an adjustment screw. Harley plugs it up so people don't play with it. You have to just drill out the plug this will set your air fuel. Whenever I take a carb off I drill out that plug. Heat your bike up operating temp and ear tune that screw. Only other way is with air fuel analizer or a dyno. good luck.also that backfire is caused by fuel hitting your exhaust when you let off just to let you know.
SOURCE: assy of starter clutch on 2003 Harley Davidson
The starter on a late model Harley is a typical Nippondenso gear reduction type starter. They are all basically the same except for size.
To replace the starter clutch inside the starter assembly requires disassembly of the starter assembly.
I you will contact me directly, I will scan the procedure and drawings out of a service manual for you.
[email protected]
101 views
Usually answered in minutes!
×