SOURCE: cAN i install clutch to
If it is a automatic, i wouldnt have thought so, i would imagine you would have to purchase a manual engine :)
SOURCE: some not so nice person
Where exactly was the debris inserted?
If it's in the fuel tank, then the tank must be drained and removed to clear out the debris and the fuel lines up to and including the filter will need to be checked and replaced if needed. The fuel filter must also be replaced at the same time.
If it's actually in the carburettor intake, then it will need to be removed and cleared out, and the intake manifold will also need to be removed and checked. It will also be necessary to remove the cylinder head to check for further debris, and if there is then the engine crankcase will need to be opened and cleared out. Note that if any gaskets are disturbed during disassembly then you must discard the old ones, clean the mating faces and fit new gaskets upon reassembly.
SOURCE: how to troubleshoot high voltage
Higher than normal voltage readings while the bike is running is due to a faulty voltage regulator.
SOURCE: How to replace the valve seal of honda xrm 125?
Need to take off the cylinder head and disassemble the valves off the head in order to change their oil seals.
SOURCE: Honda XRM 125 wiring problem.
Hi, I'm a 45 yr Yamaha mechanic & take this advise or not, But if your harness is been stripped open or cut up badly, You definitely need to replace it with new from a Honda dealer. You MUST have the correct year so take the 17 digit serial number with you. It is stamp on the MAIN FRAME somewhere. You can install it, It isn't very hard to do. All the plugs have matching wires & connectors. Just look at the colors of the wires going into & out of a plug. They almost always match up. The very few that don't will have the only matching plug in that section. Then if you come to a plug or wire that you don't know, Any Honda mech. can tell you that exception. Or come back to me at that point. Don't try to wire it without a good harness, You can burn out some expensive parts if not already done.
77 views
Usually answered in minutes!
×