Resetting my camera on Hero plus - Hero Motorcycles

Here's how for all GoPro cameras:

http://gopro.com/support/articles/how-to-reset-the-camera-to-factory-defaults

Yes it is possible, just go to hero service centre

Approx 700 to 800 rs

40000 kms is approx life span of Passion Plus Chain Sprocket

Always use Hero Honda 4T plus 20W40 Engine oil and after filling this oil, next oil replacement is after 4000kms.

Oil Filling Procedure: Drain the Old oil and tell the technician to remove the clutch case and remove the rotor and clean the clean the rotor, and then while fitting the clutch case need to replace the rotor gasket and clutch gasket.

Fill only 900 ml of Engine oil, and maintain the Engine oil level between minimum level to maximum level

We've found the best way is to remove the SD card and the batteries for at least 30 seconds and then reinstall both and turn the camera on. Remember, that in addition to the data saved on the SD card, by plugging your camera into your PC with the USB cable you will be able to find any images or video stored on the camera's built in memory.

We've put together a tip sheet for the GoPro Hero 5 cameras but much of the information will help you get the most out of your Hero 3. It is important that you do not attempt to update a Hero 3 using the available GoPro firmware update as it is ONLY for wide angle Hero 5 cameras.

If we can answer any other GoPro support questions feel free to visit us at IcePlanter.com or contact GoPro directly.