How to replace a clutch cable for a 77 Suzuki GS 550

Type in Suzuki GS 550L manual into Google, there's plenty of sites

Best way is to dissconect the clutch cable at the handlebar first, lossen off the adjuster on the handle bar and take the cable out of the lever. Then the cover should come straight off, should be no need to disconect the cable from the cover in order to get it off.

The clutch cable hooks to the screw assembly. The assembly is bolted to the case. When the clutch lever is pulled in, the center part of the assembly, ( a giant screw mechanism ), pushes on the clutch rod which then pushes on the outer clutch pressure plate to separate the clutch plates. The clutch springs supply the pressure to push the clutch lever outward thus engaging the clutch to move forward. I hope this answers your question. Please rate my answer. Thanks.

A diagram of the entire bike and engine can be found at www.babbittsonline.com/pages/parts/viewbybrand/default.aspx

remove the cover behind the shift lever, remove old cable and fitting that runs into top of said cover. Next, route new cable from lever along handle bar, run under gas tank and then between the first and second carborators poke cable through hole at the cover,thread in fitting,attach to spring actuater adjust as needed,

yes,,, drop it in the repair shop it the easy way forwards, but if cash is tight, go and buy a repair book for your bike but you will still need tools to do the job right, and its not easy to do,,, get a pall to do it for you???? and give him a drink for it?

Try the Suzuki forum on line - Old bike and new - They do help

you do need to take the clamp on section of the shiffter off. You shouldn't loose any oil unless you have other issue. just remove the outer cover and you will see where the cable connects, piece of cake. good luck

http://www.alpha-sports.com/suzuki_parts.htm

try here