The batteries are 2 per box the boxes fit on top of each other..top box connects to bike and connects to bottom box.. top box has 2 positive and 2 negative..bottom has 3 1 positive 1 negative and 1 small 1 that connects to both batteries..
SOURCE: Kenmore Electric Dryer Model # 110.62622101
I think on your machine the lower thermostat connected to one terminal of the element, you have a wire coming from the thermal cut off down to the top terminal of the lower thermostat, a wire from the lower thermostat to the timer, and a wire going to the other terminal of the element.
You probably have the wire from the cut-off correct as it won't reach the other terminals. You have crossed the other 2 wires. This caused 240V to short across the lower thermostat and burned it out.
You will need a new Hi-limit thermostat, which will include the upper cut-off as well. They come as a set part# 279816. This will be a little different because the new hi-limit will not connect directly to the element. There will be all the wire ends and instructions with it that you need to get it hooked up correctly.
There should be a wiring diagram inside the console of the dryer that shows which wires go where, but I am sure you have crossed the 2 wires below the hi-limit switch.
Post back if you need any help.
Thanks/Mike
SOURCE: How to jump start flat battery for R33 using fuse
use the engine as the earth say an engine bolt ect
SOURCE: 1989Fzr6 3he bike/ 1995 4jh engine
does the bike have a fuel pump?what carbs are you running ?are the carbs in sync?
SOURCE: Starter relay connections
if your starter engages but wont spin check to make sure the starter housing is making good contact on the bell housing or it wont ground out
232 views
Usually answered in minutes!
×