SOURCE: Loss of power after wash
Each of the 4 bowls on the carbs have a screw them. With the bike turned off open these to drain the fuel from them. Check each as they are draining to see if any water is any one of them, if there is this may solve your problem. For drying out the bike faster (you may have caused a short by using a pressure washer) use a leaf blower.
Good luck
SOURCE: LOST POWER WHILE RIDING
It is likely that youve popped a fuse
The battery would have to be totalled to behave like that
But it sounds like the battery isnt being charged properly. Make sure the voltage across the batt terminals is at least 13.5v at tickover rising to no more than 15.5v at higher revs
Make sure the battery connections are TIGHT as well
Ride-Safe
Bike-Doc
Please mark this as helpful (if it has been!!)
SOURCE: I have a 2007 VN 900 bike has approx 11500 miles
then your stator or regulator is bad on your bike.
SOURCE: Battery dead. I jumped started it and rode around
no sorry its an automatic
well there is a way if you can get the bike up to 40mph either going down a hill or being towed failing that then no
John
97 views
Usually answered in minutes!
You now have water inside your carb. You will need to remove the float bowl to get the water out of the carb.
×