SOURCE: Jeep won;t start..new fuel pump installed
try the fuel filter and make sure you have proper oil pressure!! Remeber if you have tried craking to many bad times then the plugs are going to be fouled out!! Means that they are going to be drowned with gas and need replacing!! Also make sure your fuel pump is coming on!! You should hear a hissin or a hummin noise back from the fuel tank!
SOURCE: I need to replace the clutch in my sons tao tao
You'll need a Clutch Hub Nut like this one:
http://www.compacc.com/p.cfm/c/1111010/p/18219
You'll also need to hook it up to an Impact Driver like this one:
http://www.amazon.com/Bare-Tool-DC825B-18-Volt-Cordless-Battery/dp/B002RT7K4Q/ref=sr_1_6?ie=UTF8&s=hi&qid=1260243742&sr=1-6
Remove the engine cover (on the right). If you damage the gasket (most likely), you'll need to replace it when reassembling. Unscrew clutch top (4 screws). Use a flat screw driver to release washer lock (it holds clutch nut locked. Only one of several locks would be engaged). Use impact driver to unscrew clutch nut. Remove nut and 2 washers. Remove clutch. Reverse process to install new clutch.
Visit emotorbike.com for more info. Or call 856-782-9189.
SOURCE: need wiring diagram for electric
Based on the original Honda spec, you can see a diagram here:
http://www.buyatvsonline.com/chinese-atv-110-wiring-diagram-p-10430.html
SOURCE: I have a craftsman 32cc weedwacker gas trimmer,
No more Mr. nice guy. But it sounds like your just out of adjustment, try readjusting your high idle screw. Good Luck..
236 views
Usually answered in minutes!
×