Question about Motorcycles

1 Answer

My Lifecycle 6500 will not turn on when I pedal and press the start button. The panel has a 9 volt battery which I replaced but it still doesn't turn on. What else can I try?

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Motorcycles Master
  • 66,248 Answers

TIS NOT A MOTOR CYCLE TRY POSTING IN THE PROPER CATEGORY

Posted on Dec 06, 2019

Ad

6 Suggested Answers

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
maxtreadmill

John Mazmanian

  • 832 Answers

SOURCE: How can I determine which Lifecycle I own.. I

On the bottom the bike frame their should be s# plate. If you need to replace the battery you need to: first remove the foot pedals,then side panels.

A 6v @ 2.5Ah battery should be in the frame p01001700030685.jpg
they sold run about $20.00 to $27.00 plus S/H





Posted on Feb 28, 2010

maxtreadmill

John Mazmanian

  • 832 Answers

SOURCE: I have a lifecycle model 9500HR, will not turn on.

Some of these units have the main battery ( 6v @ 2.5AH ) inside the bike frame and a 9v in the backside of the upper console

Posted on Feb 28, 2010

Dave Bird

  • 1 Answer

SOURCE: need to replace the 9 volt battery in my kenmore freezer chest.

The manual does not tell you where its at but the 9-volt battery holder is located on the lower left side of the freezer. There is a small panel about 9" off the floor and towards the front of the freezer (left side facing). cd6fa25d-9930-4b53-8883-c0ebcde8413d1.03.01

Posted on Sep 12, 2010

Strattrpt

Dave

  • 159 Answers

SOURCE: 1991 Lexus 400 - engine

This could be a problem with your starter -- if you know a bit about engines try tapping the starter with a wrench while someone turns the key (not too hard so you don't damage it if this is not the problem). If your starter motor has a "dead spot" tapping it can get it to free itself up and might help. If this DOES help, please consider changing your starter so you don't have to keep going through this problem. If tapping the starter does not help, it might just be dead altogether. If you are doing your own work, try replacing it and hopefully that should help. If you are not going to do your own work on the car, a mechanic should be able to give you a proper diagnosis and repair the issue without too much hassle.

Posted on Jun 01, 2011

Daniel Morton

  • 747 Answers

SOURCE: car wont start unless boosted battery shows 12 volts with meter key off and 9 volt when tried to start

After you get it started check to see what the output of your alternator is it should be 14.4 volts if this is the reading your battery may be bad you do need a certain amount of not only voltage to start but also amps from the battery

Posted on Sep 17, 2012

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My Lifecycle 6500 will not turn on when I pedal and press the start button. The panel has a 9-volt battery which I replced but it still doesn’t turn on. What else can I try?


Besides the battery, which you’ve checked already, you can disconnect the harness and reconnect it. This is usually the cause for the issue. Remember also that if your revolutions are below 40 per minute, it can cause the same problem.

Apr 21, 2018 | Cars & Trucks

1 Answer

When I try to start my Moto Guzzi Norge (2010) it just makes a clunk and doesn’t turn. Battery is new.


Bad connection or faulty starter. Check voltage/current to the starter when you press start - should be around 8/9 volts for a 12 volt system - if considerably higher suspect starter, if lower and little current flowing suspect poor connection somewhere. If the voltage is low and current high suspect starter.

Apr 16, 2018 | Moto Guzzi Motorcycles

1 Answer

Looking for location of battery in LifeFitness C9i exercise bike. (C7i battery was in control panel, earlier models may have been in the base.) Thanks!


How do replace the battery in Lifecycle C9i exercise

The web site above states the following:

The 9 volt battery for the display on the bars of the bicycle goes in underneath the display (on the bottom of it).You can also see the 7th page (pages are not numbered, simply scroll to the 2nd to last page) of the manual at the link below to see where the battery installs:

https://www.lifefitness.es/static-assets/document/manuals/C9iAssemblyInstructions_12-07-05.pdf

Feb 16, 2018 | Exercise & Fitness

1 Answer

Lifecycle 6500. Why doesn't console light?


The rain seeped in and shorted it.

Nov 17, 2015 | Exercise & Fitness

1 Answer

I changed the 6 volt battery when i connect the battery leads and used machine i press clear/pause button it will start again. I have to disconnect the battery to turn it off


If no key is pressed for 15 seconds, and the user stops pedaling, the console shuts down. You can also do the same when starting the machine, just step on the pedals to get them moving and the console should light up.

Dec 13, 2014 | Life Fitness 9500 HR Crosstrainer Rear...

1 Answer

Have a 2007 rx-8, car turns over but will not start, keeping gas pedal down to the floorboard doesn't work. Battery drops to about 11 volts when you crank


Need to try and isolate which system is preventing it from starting. Make sure fuel pump is running, you should hear it come on for a couple seconds when you turn the key to on. 11 volts is not that bad, you are usually good down to 9v.

Apr 14, 2013 | 2004 Mazda RX-8

1 Answer

04 roadglide want start. Replaced battery, now i here a clicking noise by the starter when i press start button.


Hi Anonymous, first when checking anything in the starter circuit you must make sure the battery connections are clean and tight especially the negative cable at both ends and has a 12.5 volt or better charge. It must not fall below 9 volts during the cranking procedure with a volt meter hooked up. If it does fall below 9 volts do a proper load test on the battery and replace if necessary. Second replace the starter relay cheap $6 and make sure it's well grounded and getting 11.5 volts or better to activate. Third remove the back cover of the starter solenoid and de-arc/refurbish the contact plate and shoes making sure they are tight. If it still chatters replace the solenoid. Good luck and have nice day.

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/gregg_c0ec1df182c7330e

Nov 10, 2012 | 2004 Harley Davidson FLTRI Road Glide

1 Answer

Where is battery located for LifeFitness' Lifecycle 9500HR


The Lifefitness Lifesyscle 9500HR battery location is at in the lower portion of the recumbent bike. This is a 1/2 to one hour task for most do it yourself'er.
In order to gain access to the battery compartment,you has to remove the pedals.
The center cover has to be remove.
The 6V battery will be within 12" from the pedals. mustgo_52.jpg

Additional reference: Lifecycle Battery 0819-0012 Model Description Terminal Volts AH L W H Lbs Price 0819-0012 Fits Lifecycle Stairmaster series 4200, 4400 - Lifecycle Lifefitness CT8500, CT9100, 9500HR, 95Ci - Star Trac 5300/6300, 5400/6400, StarTrac 6100 Pro, 6200 Elite, ET4600 (0819-0012 replaces the 0819-1006) F2 6 2.5 4.48 1.81 2.75 2 $19.80

Feb 02, 2011 | Life Fitness Exercise & Fitness

1 Answer

How can I determine which Lifecycle I own.. I purchased it second hand (X-Balley) and other then Lifecycle HR on its side I see nothing else discribing it. The battery is in need of replacement. I...


On the bottom the bike frame their should be s# plate. If you need to replace the battery you need to: first remove the foot pedals,then side panels.

A 6v @ 2.5Ah battery should be in the frame p01001700030685.jpg
they sold run about $20.00 to $27.00 plus S/H





Feb 26, 2010 | Life Fitness 9500RHRT Recumbent Bike

1 Answer

I have a lifecycle model 9500HR, will not turn on.


Some of these units have the main battery ( 6v @ 2.5AH ) inside the bike frame and a 9v in the backside of the upper console

Feb 18, 2010 | Exercise & Fitness

Not finding what you are looking for?
Motorcycles Logo

Related Topics:

29 people viewed this question

Ask a Question

Usually answered in minutes!

Top Motorcycles Experts

Arnie Burke
Arnie Burke

Level 3 Expert

6096 Answers

Marvin
Marvin

Level 3 Expert

85222 Answers

richard libby

Level 2 Expert

209 Answers

Are you a Motorcycle Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...