At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.
i hotwired my 86 honda nighthawk 450, but just toggled the red and black, used the contact plate from the bottom of the ignition switch but now it registers nothing after only firing up three times, i have the new ignition key switch in but still nothing, whats wtrong with iti hotwired my 86 honda nighthawk 450, but just toggled the red and black, used the contact plate from the bottom of the ignition switch but now it registers nothing after only firing up three times, i have the new ignition key switch in but still nothing, whats wtrong with it
You can't post conmments that contain an email address.
Re: How do you unplug an ignition switch on a 1984 honda...
You are going to haveto trace the line into the bike and unclip it from the harness. after that you are going to have to remove it from the mount and then you are done.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
this happened to me, and the key would come out when it was in the on position. turns out the pins were worn inside the ignition switch and it just needed to be replaced
No neutral light, will not start without clutch lever pulled in (and possibly sidestand up, if it has a safety switch). If the broken wire is touching a ground, the neutral light will not go off.
Check the main fuse. It is a 30A fuse, separate from the bike's other fuses. Also verify that the wires near the starter solenoid are connected correctly, securly, and are free of corrosion.
If the fuses are all good and everything is plugged in correctly, you may find that the ignition switch is bad - or has a melted connector on the back. This is a common problem with many Hondas of that vintage.
i hotwired my 86 honda nighthawk 450, but just toggled the red and black, used the contact plate from the bottom of the ignition switch but now it registers nothing after only firing up three times, i have the new ignition key switch in but still nothing, whats wtrong with it
×