My 2006 125 Eliminator just got a reupholstered seat. Remove hex bolt at the very rear of seat. Remove right side plastic cover over battery (open with key, pull off cover) .Remove plastic cover on left side (2 large phillips head screws.) Remove 2 stainless hex heads on each side of bike that hold chromed plastic sleeves under passenger part of seat (4 hex heads). Then remove 2 smaller black hex heads (one on each side) under point where tapered passenger part of seat begins. Slide seat toward rear of bike do disengage from metal lip that holds down the front.
Be sure to use metric hex wrenches. 15 minutes or less off or on.
good luck
ride easy
Dig your fingers deep into the front or back of the seat,you should feel a clip and then pull on it
3,848 views
Usually answered in minutes!
×