1992 Suzuki Intruder Clutch problem

It sounds like the seals or u might have a leak in the system

Sounds like you either need to adjust the clutch cable - there should be a little bit of play in it before it disengages the clutch - or you need a new clutch kit (plates, springs, etc). What mileage is on the bike and has the clutch ever been changed?

can you get it out of gear?
can you change gear
does the clutch drag ( shifts are difficult )
the clutch plates are froze/ stuck together, remove clutch, check plates for rust clean soak in fresh oil replace any that are rusty..

Not adjustable attached to the underside of the lever, remove from clutch some switches are cliped together in 2 halves & will split in half if you release the clips others wont, spray a little thin oil around switch if problem continues replace

the system is hydrolic there is know cable if it is engaging or slipping it is probably worn and needs replaced

does the clutch lever release "sharply" and snap back after engagement? then lean bike over drain about a quart of oil, take off access cover to clutch and check to see if you have any broken clutch springs. if thats looks o.k. you"ll probably need new clutch plates. a real quick check when you ride the bike smell the oil, does it smell burnt? if it does, the plates are probably no good.

you must check the clutch,worn or distorted pressure plate,distorted clutch plate

shift fork in trans is not engaging need to let someone open trans and sovle the issue those trans are not hard to fix but if you dont know how the shift fork needs to be to fuction seek pro help