SOURCE: removing the seat of V-Star 1100 Classic 2001?
is this just the seat itself or the seat cover? if its the seat assembly there should be 2 bolts holding the seat down located somewhere around the rear of the seat aprox 2 inches below the seat. if your talking about the seat cover you have to remove the staples thats holding the fabric down to the seat pan.
It's not adjustable. If you need more damping you can change the fork oil to a heavier weight. Put 15w instead of 10w for example. You could also put stiffer springs inside your forks. Rather large job. You could also put a spacer either on top or under the springs you have to get the effect of stiffer springs without actually changing it. Also a large job, but less expensive than new springs. Finally, check your fork seals. If the seals are bad you should see oil leaking from them and that would cause loss of damping.
SOURCE: My suspension was set up for someone weighing 220
you wont get it right with these springs. you will have to put in lighter springs
1,185 views
Usually answered in minutes!
×