SOURCE: CRF 50cc won't start after giving it a hose down.
hi mczukli,
you may want to blow-dry the spark . block, piston out.
just a piece of reminder, do not use too much pressure on the water and hit the bike on the engine part. Not all screws are torqued to be water tight. so water may get in, then rust it out then ruin your ride.
SOURCE: Rebuilt carbs. flooding rear cylinder
My bike started doing the same thing. I pulled the carbs put new kits in them and it still does the same thing. It does not seem like a spark issue because the fuel consumption would not be this bad, but the floats looked good. The needle valves and seats are new. I am not sure what to think at this point. I even replaced the intake manifolds and flushed my fuel system. It starts good initially. It is almost like the fuel pump is pushing to much pressure and over coming the needle valve. Has anyone seen this before?
Thanks,
SOURCE: my derby gp1 open 50cc.when you put revs on dies
Hi and welcome to FixYa,
Initially, check for:
Postback results of above initial tests.
Good luck and thank you for asking FixYa.
507 views
Usually answered in minutes!
×