Where is the coolant drain for a 1993 vt600 Honda Shadow

SOURCE: Where is the thermostat located on a 1985 honda shadow vt 500?

I've got the service manual if you want it?

SOURCE: honda shadow vt600 dumping fuel into the carbs

Hello ddsaul2...If it's only been a day since the shop adjusted the carbs. you need to return it to them and make them do it right.
Sounds like a float valve is stuck and not closeing.They may have cracked a seat... There could be a pin hole in one of the floats causeing it to fill up with gas and sink. You can check and make sure all the vacuum lines are connected and possibly GENTLY tap on the carb fuel bowls to see if the float might be stuck alll the way down. Personally...if i paid for a carb tune i'd make them fix it. Surely they gurantee their work.
Good luck...i hope this helps

SOURCE: where is the battery on a 2004 honda shadow vt600?

It is located underneath the seat.
You remove the right hand plastic cover under the seat and you will see another cover which holds relays and stuff.If you remove that too you will see the battery.
Check here for details

SOURCE: how to change cooling fluid on honda shadow vt600

There is a petcocke on bottom of radiator to open and drain fluid. Then refill through tube or highest part of radiator with 50/50 mixture

SOURCE: how do i install saddlebags on a 2007 honda shadow

I've got a 2007 Shadow and recently put on a set of saddlebags. What you do is use a large allen wrench or star wrench on the seat strap to take out those two bolts, and then you slide the seat towards the back of the bike (or perhaps you need to slide it to the front, I forget, its just the "picture-hanging" connection, <=0 is the shape of the hole on the seat, and on the bike beneath it is a peg, with the seat hole large enough to slide the peg through, but once you shift the seat to its natural position the head of the peg is at a place too narrow to come off, hence the sliding motion to remove it) . Then it is smooth sailing, just lay your saddlebags over the peg with the seat removed, and try and put the seat back without disrupting the bags too much, which can be hard since its a pretty snug fit. Hopefully that helped, I don't know if the request was talking about post market support frames or something