SOURCE: replace rear brake pads
Remove right saddlebag, pull the two caliper mounting bolts and remove the caliper. Do not open bleeder or disconnect line. You will need to push a large screwdriver between the old pads before removing them in order to push the pucks back into the caliper or the new pads will not spread enough to reinstall. Then pull the two smaller bolts from the caliper and the pads will fall out. The pads are different for inside and outside, so pay attention, and remember, after reinstalling, before riding, be sure to pump brake pedal, and it may take a few stops before brakes stop as effectively as before.
SOURCE: I need touch up paint for my 2000 electra glide
2000
Aztec Orange Pearlcoat 61889
Birch White 90303
Bronze Pearl 62074
Chrome Yellow 84454
Cobalt Blue Pearlcoat 191058
Diamond Ice Pearlcoat 37056
Ice White 92151
Luxury Rich Red 75946
Sinister Blue Pearl 190524
Suede Green Pearl 400442
Viking Purple/Concord Purple Pearl 52788
Vivid Black 9850
White Hightlight Pearl 92151/92152
SOURCE: WHERE ARE THE FUSES ON
under the panel in front of the left saddel bag as you stand behind the bike also starter releay is on the other side
SOURCE: How do you remove the tour pack on 2007 Electra
Disconnect all of the electrical connections including the antenna wire from under the seat going to the tour pack and then remove the four nuts under the tour pack which holds it to the mount. At this point, simply lift it off.
1,359 views
Usually answered in minutes!
×