- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Typically, there is a ring that screws onto the front of the switch which mounts to the holder from the back. Remove the ring, the switch falls out. I dont know if yours is "typical", however.
Better yet, take your serial number to your Suzuki dealer, ahd he or she can cut you a key based on that number. For that matter, so to can a good locksmith. No need to remove the switch.
TRY THIS IF DONT WORK DEALERSHIP HAS TO REPROGRAM TRANSMITTER.REMOVE KEY FROM THE IGNITION SWITCH.CLOSE ALL DOORS.SWITCH IGNITION ON.WITH IN 10 SECONDS, SWITCH IGNITION OFF AND REMOVE KEY.WITHIN 20 SECONDS, PRESS AND RELEASE DRIVERS DOOR COURTESY LIGHT SWITCH 3 TIMES, SWITCH IGNITION ON, WITHIN 10 SECONDS ,SWITCH IGNITION OFFAND REMOVE KEY.LOCKS WILL CYCLE TO CONFIRM PROGRAMMING MODE ACTIVATED. PRESS THE UNLOCK DOOR BUTTON TO CONFIRM THE DOORS OPERATE FROM LOCK TO UNLOCK. REPEAT PROCEDURE REMAINING REMOTE TRANSMITTER.IF THIS DONT WORK DEALERSHIP WILL HAVE TO REPROGRAM NEW REMOTE.
I assume you dumped out the half pint of old gas and rinsed out the tank. Get a new spark plug and clean the air filter. Remove the carb and dis-assemble it then soak the parts in denatured alcohol for 30 minutes. Do not soak the rubber diaphragm. Finish the cleaning with a can of spray carb cleaner from the auto parts store. Be sure all internal fuel and air circuits are clear and that the diaphragm is not torn or has pin holes. The top cap must have a good seal. Go to www.babbittsonline.com/parts/viewbybrand/parts.aspx to see a diagram of the carb and the rest of the bike. It looks like they have lots of parts for your bike.
ignition has bent pins
insert key tap it with malat
once key turns take car to lock smith for repair they can sand the pins once fixed remove some of the keys off your ring do not remove key b4 turning after wacking the thing with malat
failing this call mobile lock smith they are still cheeper than dealer and can fix on sight
new ignition from dealer 200 bucks cost to install it at dealer 200 bucks
locksmith will usually charge 50 - 125 to fix curent ignition 125 would include mobile visit usually
get a free pdf service manual for your bike here. you should find out how to remove the ignition. or if you have a seat lock that is easier to remove take that to a locksmiths to get new key cut
×