SOURCE: '95 Yamaha YZ 125 clutch - stays in gear when clutch is pulled in
hey dude,, just thought id come in and give u some tips or 3,, i take it when u pull clutch lever in, and try and change gear it feels like your foot will snap b4 it goes in gear,, if that makes sense,, firstly mate,is to make sure the clutch cable slides freely ,easest way is to take cable off and just grab 1 end and make sure it isnt sticky,, if so dip one end of the cable in a bit of old oil ,,whilst holdin the other end ,pull and push the cable inner, this will **** up a bit of lubricant inside the cable ,, keep doin this each end till free to move, ,,next step if the cables ok,,, and may need help if u dont no,drain the oil out,,and as u r sat on the bike is to remove the clutch casing on the right hand side of the moter,where the bottom end of the cable goes,remove the casing being carefull not damage the gasket,,then u will see clutch plates and friction plates housed,, undo the 7 or 8 spring loaded bolts carefully take the first fibre plate out then metal friction plate then another fibre plate and so on,, wen u take the 1st plate out place that on the bench ,stacking each plate on top of one another, cause they have to go back in as they came out,,wen out,,u need a piece of wet n dry paper ,or fine emery,,and just wipe round both sides of the fibre plates taking the shine off them,as u put them back in,, put casing back on with a decent gasket,, oil back in cable on, make sure cable has no free play on the lever so wen u r about to pull lever in it bite straight away,, start her up, warm it up and try it,,any probs still il eat my shoe,, take care m8
SOURCE: !983 honda magna v45 clutch not engaging
if you rebuilt your carburetors you have made a mistake when you reassembled them a carb must sprsy a fine mist of "dry" fuel into the engine intake your carbs are flooding you need to check your fuel floats , jets and, don't forget to check the power piston circuit and, balance (sync) your carbs on the bike when you're done
your chuch is fine if you did not touch it
SOURCE: cbr 600 f3 will not start
wow, 7 years without use! try to check if the fuel pump motor is still working... also check the fuel lines if its clogged.. I hope you get your bike up and running again... feel that adrenaline rush when going 100+mph.. hehehe.. have a good one bro...
SOURCE: bike won't start
Check compression ratio and valves clearance.The carbs leak any fuel from their o-rings.Spray through the air box with a carb cleaner spray while pressing start button but little bit at a time.Don't twist the throttle too much and always use choke until she fires up for good.
SOURCE: Motor dies in first (or any ) gear.
well, if you checked the fuel system and all is clean, with new plugs , all is left to test is the ignition coil, its contacts and cables
69 views
Usually answered in minutes!
you say kick stand is up ...but does the kickstand switch work properly?
×