2005 Derbi Senda SM 125 4T Logo

Related Topics:

A
Anonymous Posted on Jan 25, 2011

I'm having problems with my Derbi senda 125sm, at first the bike will start fine and tick over without trouble, but after about 15 minutes of riding the bike will cut out and will not start with the electric start and will have to be bump started, and this bike does not have a kick start and then proceeds to cut out every 3-5 miles. need help ASAP thanks.

5 Related Answers

Anonymous

  • 2712 Answers
  • Posted on Nov 10, 2008

SOURCE: Drain and change oil

I can't tell you all the particulars from the limited amount of pictures of your bike. -Remove the oil drain bolt on the bottom of the crankcase (the universal bolt size for bikes use a 17mm wrench). -Drain the oil (remember to recycle). -Re-install the drain bolt with a new sealing washer if necessary. -The oil fill cap should be some where on the top of the crankcase. About 1 or 25mm in diameter with a raised tab for turning. -Fill with recommended oil. -There are 2 ways to check oil level on dirt bikes: 1) Oil level check bolt. On the right side cover. 2) Oil level site glass. A 1 round piece of glass on the side of the crankcase. Usually by the kick start & R brake lever. -Always check the oil level with the bike upright (as if you were sitting on it). -Check bolt - fill with oil slowly until oil comes out of the check bolt and re-install it. -Sight glass - fill with oil to cover 3/4 of the sight glass. -Remember to hold the bike upright when adding oil.,

Ad

Anonymous

  • 1066 Answers
  • Posted on Mar 24, 2009

SOURCE: clutch and pistonring

on the internet.

coetzee_phil

  • 140 Answers
  • Posted on Oct 16, 2009

SOURCE: 50cc 1999 derbi senda

Hi
Decarbonise the exhaust system.

Regards
Phillip

Anonymous

  • 4 Answers
  • Posted on Oct 19, 2009

SOURCE: I have an 04 RMZ 250 I just re-shimmed the valves

sounds like maybe valves were shimmed too tight,check service manual for clearances...better a little loose than too tight,can cause alot of damage to cam & head,be careful!!

Anonymous

  • 1 Answer
  • Posted on Mar 18, 2010

SOURCE: fitting back kick start spring mechanism derbi

Hi I have a derbi senda sm 2005 Just brought a kickstart shaft but carnt rember how to fit it n how the springs go If any1 can help please let me no

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

Cutting out at top end.

Adjust the mixture screw outwards about half a turn at a time to make it richer it is running too lean at the top end
0helpful
1answer

Spark plug locatio on derbi senda 50cc

The spark plug is located at the top of the engine under the tank. It is the rubber plug cap (usually black) located in the middle of the cylinder head that you must pull off to get at the spark plug

Ride safe
Bike-Doc
Please mark this as very helpful (if it has been!!)
Not finding what you are looking for?

245 views

Ask a Question

Usually answered in minutes!

Top Derbi Experts

Brad Brown

Level 3 Expert

19187 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

 Mikey
Mikey

Level 3 Expert

6904 Answers

Are you a Derbi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...