1994 Honda CBR 900 RR Fireblade Logo
Posted on Feb 01, 2011
Answered by a Fixya Expert

Trustworthy Expert Solutions

At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.

View Our Top Experts

Starts, runs when i shut off with on/off switch will not start up must turn key off wait a few min.turn key on and start.if i shut off with key starts up

1 Answer

Anonymous

Level 2:

An expert who has achieved level 2 by getting 100 points

MVP:

An expert that got 5 achievements.

Governor:

An expert whose answer got voted for 20 times.

New Friend:

An expert that has 1 follower.

  • Expert 88 Answers
  • Posted on Feb 02, 2011
Anonymous
Expert
Level 2:

An expert who has achieved level 2 by getting 100 points

MVP:

An expert that got 5 achievements.

Governor:

An expert whose answer got voted for 20 times.

New Friend:

An expert that has 1 follower.

Joined: Feb 02, 2011
Answers
88
Questions
0
Helped
33288
Points
158

Hi
then you look at the cables that attach to the battery, the better the positive battery cable that lands on a black box with a red connector. what it usually is "roasted" 'cause faulty contact between the tabs (male-female) oxide can usually do ... or is it current controller and that 'that sort of plate with two holes for screws M6 or M5 on the side that goes to the dogs ... changing it and finding it on ebay or other sites or ads you should see it
Alex

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

How do i reset immobiliser after changing ignition

it depends on the make of car but most will do a 30 min relearn.turn the key to the start position release it back into "run"wait 10 min, cycle the key from run to off and immediately turn it back to run (do not attempt to start at this point) do this for a total of 3 times and at the completion of the 3rd cycle without shutting off the key attempt to start the car
0helpful
1answer

Where is the idle located on a 1994 Jeep Grand Cherokee limited

It sounds like you do have a relay problem try switching relays around that have the same part number start with the starter relay when switching the make sure the key is off each time
0helpful
1answer

1991 park ave. flashing vats turn key on wait 10 mins. start car does start buy misses

This link will help.

http://vatspasslockpasskeysecurityhelp.yolasite.com/
0helpful
1answer

Changed ignition switch and now the car thinks it's being stolen. It shuts off the gas flow. Does anyone have the code or know how to reprogram for the new switch?

YOU HAVE A PASSLOCK SYSTEM WHEN YOU TURN THE KEY THE COMPTER READS IT OK OK RESET YOU MUST DO THIS
1 TRY TO START VEH AND LEAVE IN RUN POSITION FOR 10 MINS
2 DO IT AGAIN
3 DO IT AGAIN
FOR A TOTAL OF 30 MINS THIS DOESNT ALWAYS TAKE THE FIRST TIME. MAY HAVE TO DO IT MORE THEN ONCE AGAIN TRY TO START VEH AND JUST LET THE KEY GO AND WAIT 10 MIN 3 TIMES
0helpful
1answer

Gas dryer runs for 30 mins then shuts off.

This is a common problem that is not a good one. But the motor is goin bad. If you try to start it you will hear like a hum then start. Motor is going bad and over heating and shutting down on overload. Sorry. Hope this helps.
3helpful
1answer

1999 Pontiac Sunfire ignition lock cylinder changed but car has anti theft and car wont start. How can I get it to start?

try turning the ignition on try to start then without shutting key off wait 10 mins then shut key off then back on but do not try starting leave on for ten mins then back off turn key back on to run but do not try starting it wait ten mins then if it reset it should crank over and start if not repeat all steps again
2helpful
3answers

89 regal won,t start but after 5 or 10 min. runs great

sounds like your fuel pump is going out. One thought might be that the fuel filter is causing enough resistance to over heat the pump. I would check the fule pressure to determine a free flow of fuel.
Not finding what you are looking for?

92 views

Ask a Question

Usually answered in minutes!

Top Honda Experts

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Sean Wright
Sean Wright

Level 3 Expert

2045 Answers

Mike Cairns
Mike Cairns

Level 3 Expert

3054 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...