How do i get the seat off my 03 zx 636 - 2003 kawasaki ZX-6R

Kawasaki ZX600 636 ZX 6R 1995 2002 Haynes Service and Repair Manual Series...

Kawasaki Ninja ZX 6R 7R 1985 2009 Workshop Repair Service Manual Quality...

Search Results Page 1 of 1 Clymer Manuals Kawasaki Ninja ZX 6 1990 2004...

Sounds like it's time for a valve adjustment.
clearances are:
exhaust .22 - .31
intake .11 - .19
Checking clearance should be very simple but adjusting requires cam and lifter removal and different size shims underneath.

Good luck, i hope this helps.

Probably a worn chain will cause that. Check your chain and sprockets.

get one of these,, don't depend on anything/one else..

Search

https://haynes.com/en-us/kawasaki-ninja-zx-6r-zx-6rr-03-06-haynes-repair-manual

there should be a key hole under the left side of the back fairing, put the key in a turn in and pull the back seat off.

voltage reg. may be bad.19 Volt DC will destroy other electrical, dont run it and risk it.

chec wires for contact n corrosion--is the batt healthy--chec starter relay

you use the key to remove the rear seat and once thats off there is a little bracket that is bolted that holds the front seat on unbolt and then you can remove the front seat

Gday. . Remove both your seats, this allows you to be able to undo the 2 bolts to the tank that sit under your seat, theres 2 bolts at the front of tank that need to be removed. As your lifting tank off youll need to remove the fuel line as well. make sure to turn fuel tap off before removing. Once tank is off youll see what needs to be done from there. Pretty straight forward

The frame mounting points are completely different. A zx 636 frame wraps around the motor where as a zx10r frame goes directly over the motor. That's how they keep the zx10r nimble enough to feel like a 600cc sport bike. But in this day and age if you have enough time and money you can accomplish anything. Honestly it's just easier to sell your 6 and buy a 1 liter.