Stihl Chainsaw Cutoff Saw Flywheel 08 S Ts350 P835 Logo

Related Topics:

Anonymous
Anonymous Posted on Apr 02, 2011
Answered

My stihl ts 760 , no gas going to carb. I have changed all filter , fuel, air, all gaskets , all gas hoses, new decompression valve, plug, cleaned carb. was working before this . Any ideas?

Answer This Question
  • Anonymous Mar 12, 2014

    Carb problems

×

2 Answers

Anonymous

Level 1:

An expert who has achieved level 1.
New Friend:

An expert that has 1 follower.

  • Contributor 1 Answer
  • Posted on Aug 29, 2012
Anonymous
Contributor
Level 1:

An expert who has achieved level 1.
New Friend:

An expert that has 1 follower.

Joined: Aug 29, 2012
Answers
1
Questions
0
Helped
861
Points
1

Sounds like the diaphragm in the carby is shot, Ebay sells new complete carbies for $76. Also check needle and seat, by pulling off carby and blowing in the fuel inlet while the cover plate is off. push up and down on the needle and seat, air should go through when you have it open. Good luck

vince janis

vince janis

Level 3:

An expert who has achieved level 3 by getting 1000 points
All-Star:

An expert that got 10 achievements.
MVP:

An expert that got 5 achievements.
Vice President:

An expert whose answer got voted for 100 times.

  • Master 718 Answers
  • Posted on Apr 03, 2011
vince janis
Master
Level 3:

An expert who has achieved level 3 by getting 1000 points
All-Star:

An expert that got 10 achievements.
MVP:

An expert that got 5 achievements.
Vice President:

An expert whose answer got voted for 100 times.

Joined: Aug 30, 2009
Answers
718
Questions
3
Helped
256222
Points
1742

Clean it again you missed something or maybe a gasket is on wrong. If you went through all of that it should run fine. Stihl usually rebuilds and runs well. Slow down turbo maybe you got a little ahead of yourself. Good Luck...

  • Anonymous Apr 03, 2011

    I was wondering maybe I have low compression ? How can I check besides removing the spark plug and blocking with my thumb ?

  • vince janis
    vince janis Apr 03, 2011

    You can set up a pressure gauge to check compression or take it to your local repair center and have them check compression but it might cost a little. If you try to make one yourself be careful to get the thread match correct on your plug hole.

×

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

Where is the decompression release on a Stihl ts420

Hyway decompression valve fits Stihl TS400, TS410 ...

https://www.amazon.ca > Hyway-decompression-valve-...
Hyway brand decompression valve. Fits: Stihl TS400, TS410, TS420, TS460, TS700, TS800 cut off saws. Replaces OEM part: 4223 020 9400 ...


Here is your MANUAL. Page 39 says not all have a decompression lever. Perhaps you can retrofit?

STIHL TS 410, 420

https://www.stihlusa.com > instructionmanuals > stihl...
PDF
TS 410, TS 420. English. 1. This instruction manual ... Contact your STIHL dealer or the STIHL ... manual. WARNING. Because this cut-off machine is a high-.


..
Read full answer
Jan 06, 2022 • Stihl Garden
0helpful
1answer

Stihl TS 760 NOT GETTING FUEL TO CARB OR PLUG BUT HAS GREAT SPARK HAS SIT FOR A WILE POSSIBLY OUTSIDE IN ELEMENTS ANY SUGGESTIONS
What's the compression like.? The carb requires the vacuum of the falling piston to draw fuel through the venturi of the carb.

Check the fuel lines are not perished or split, and fuel filter is clean..

If all of those are good then check the carb, strip it and clean it, replace any fatigued diaphragms, make sure the needle isn't stuck in the sleeve.
Read full answer
Jun 02, 2016 • Stihl Garden
0helpful
1answer

I have a stihl 015 no gas going to the carburetor I changed the gas line and filter & rebuilt the carb what should I look at
It is the check valve on the metering side of the carb. The one pressed in brass bushing with the small black check valve inside. Drill it out and cleaned the carb and jets well after. When you prime the carb you will get a little air back through the jets but I get a reliable repeatable fuel flow.
Read full answer
Apr 14, 2016 • Stihl Garden
0helpful
1answer

Stihl chainsaw problems
Your dealer is right. Gas is not a carbs best friend. every time you fuel dirt gets in the fuel tank from the air. This eventually blocks air and fuel passages and check valves inside the carb. That is the reason. Carbs wear out like anything else. Check the price of a carb compared to a kit. Some Stihl carbs are reasonable.
Read full answer
Jul 21, 2014 • Stihl Garden
0helpful
1answer

Stihl TS400 stone cutter not working (no compression) so replaced piston rings, new gasket kit and clean for carb new spark plug (good spark when engin turned over) cleaned all air filters, replaced all...
You did not indicate whether or not you have compression now that you have changed out the gaskets and piston rings. If not, it seems to me that the problem could be a) cracked head or block, b) bad valve(s) or even c) a warped head.

Sorry for the bad news (if I am right).
Read full answer
Apr 23, 2014 • Stihl Ts400 Cut Off Saw Carb Carburetor...
0helpful
2answers

Bt 360 stihl
possibly a fueling issue, check fuel filter, tank vent and possibly replace carb diaphrams.
Read full answer
Feb 25, 2014 • Stihl 08s Ts 08 350 360 Bt 360 Clutch Hub...
1helpful
1answer

My Brand new Stihl ts420 cut saw wont run full throtle, smokes white, and leaks fuel out of exhaust filter. it runs like the choke is half on.
This sounds like the carb is flooding, there is a rubber tipped needle under the metering side of the carb, this may be leaking, before replacing the needle make sure the air filter is not blocked, replace with a new filter and try again
Read full answer
Dec 14, 2011 • Stihl Ts 410 420 Cut Off Saw...
0helpful
1answer

I have put a new cylinder,piston,rings,gasket,and carb on this ts 760 and it is still bogging out when i try to cut.
try carb adjustment or carbon buildup behind muffler
Read full answer
Aug 05, 2010 • Stihl Ts 510 760 Cut Off Saw Repair...
0helpful
1answer

Stihl weed eater runs 2min. then stop
Stihl weedeater was running and stopped suddenly. Put in a new fuel filter and cleaner air filter with soap and water. Checked spark plug and it appeared fine. Started the weedeater, ran for a second or so and stopped. Spark plug wasn't gas fouled. Could it be the carburetor needing new diaphram gasket and spring.
Read full answer
Apr 23, 2009 • Ryobi Garden
9helpful
2answers

STIHL TS 400 won't start
I just repaired one with a similar problem--not getting enough gas. Two things corrected it and both were carb related. First I replaced a rather stiff diaphragm with a new one and second I reset the intake valve to allow more fuel into the carb. That solved it. Good luck.

The gas filter is weighted and should remain at the low point in the tank so it is an issue only when you are about to run out of gas--unless gas has been sitting in the tank for a long time. That can leave a film on the filter that can restrict fuel flow. Pull the fuel filter from the tank and scrap lightly on the filter. You will immediately note if there is a film on it. If so, replace the fuel filter.
Read full answer
Mar 15, 2009 • Hand Tools
Not finding what you are looking for?

View Most Popular

Chainsaw Cutoff Saw Flywheel 08 S Ts350 P835

  • Saws

Related Question

Where is the decompression release on a Stihl ts420

  • Stihl Garden

Related Topics

871 views

Ask a Question

Usually answered in minutes!

Popular Questions

How do i set up

Stihl Ts400 Cut Off Saw Carb...

Where is location of serial number on a 420 stihl

Stihl Ts 410 420 Cut Off Saw...

Hi there; my stihl ts 420 does not start easily

Stihl Ts 410 420 Cut Off Saw...

Stihl ts400 no spark even after fitting new coil

Stihl Saws

Whats the fuel oil mix of sthil ts400

Stihl Ts400 Cut Off Saw Carb...

Top Stihl Saws Experts

Cindy Wells

Level 3 Expert

6687 Answers

john h

Level 3 Expert

29490 Answers

ADMIN Eric
ADMIN Eric

Level 3 Expert

39339 Answers

Are you a Stihl Saw Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...