Question about 2000 Yamaha XJ 900 S Diversion

1 Answer

Signal fuse keeps blowing - 2000 Yamaha XJ 900 S Diversion

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Sergeant:

    An expert that hasĀ over 500 points.

    Novelist:

    An expert who has written 50 answers of more than 400 characters.

  • Yamaha Expert
  • 191 Answers

Just a hunch....if its blowing immediately, your horns are on the signal fuse....Yamaha typically wired these so the horns is hot and the horn button grounds to sound the horn. Unhook connectors and check if there is a short from either terminal to ground....one probe on a terminal, other on bike ground...retest on the other terminal. You should be open (infinity) to ground.
If fuse is fine till turn signals are used....inspect each socket for wiring damage.

Posted on Apr 21, 2011

Ad

1 Suggested Answer

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Signal fuse keeps blowing


Does the fuse blow on both left and right sides,or just blows randomly or as soon as you put the new fuse in?
Does it have tilt steering?I would check the wiring in the steering column to start.

May 18, 2017 | Cars & Trucks

1 Answer

Why does my turn signal/ hazard light fuse keep blowing out


you have a short in one of the light sockets or a worn wire from the wiring harness. could be the flasher assembly. are the turn signals different bulbs from the brake lights? Does using the brakes blow the fuse? (Rear lights or brake light switch on brake pedal). left or right turn signal blowing the fuse will tell which side has the short. 4 ways only, replace the relay.

May 21, 2015 | 2004 Jeep Grand Cherokee

1 Answer

S40, volvo, keep blowing a turn signal fuse


When a fuse keeps blowing everytime you replace it that means there is a short circuit along its cable. Check the flasher cables or call a car electrician to do it.

May 27, 2014 | 2004 Volvo S40

1 Answer

Fuse keeps blowing out


The parking lights, dash lights, turn signals, and hazard flasher should be 4 different circuits.
So you would need to know exactly what that fuse protects, then look for the short to ground.

Feb 27, 2013 | 1999 Dodge Durango

1 Answer

My 2005 buick rendezvous keeps blowing the fuse for the turn signals and brake lights. Fuse #42 in the inside fuse panel. this just started happening two days ago. Nothing is different with the car.


most likely caused by a short, could be any were. start with the light assembleys remove it and clean any rusty or coroded spotspull all bulbs clean and or replace .auto parts stores sell an electrical parts wash about 9 to 14 $ . spray as needed let dry and put back together.if it still blows fuses its some ware in the wire s , could also be at the turn signal switch or the brake switch . you would have to get it to blow to figure out witch one it is and witch one it is not example put in new fuse then keep putting on the brakes if not blown then keep doin the turn signal then check to see if blown

Jul 26, 2010 | Buick Rendezvous Cars & Trucks

1 Answer

My turn signal fuse keeps blowing why?


I am thinking you might have a electrical short in your steering column

May 04, 2010 | 1996 Chevrolet Blazer

1 Answer

2006 f150 keeps blowing turn signal fuse


It sounds like the fuse is doing what it is supposed to do, and burning out when there is a short circuit. Check the wiring from the fuse block back to the lights and pay special attention to the trailer connection.

Oct 09, 2009 | 2006 Ford F-150

1 Answer

Turn signal flasher keeps blowing


This is more than likely caused by a Bad Turn Signal Switch Housing inside the Sterring column. The one that the Handle is attached to and Wraps around the Sterring Shaft on the Inside of the Column.

Jan 23, 2009 | 1987 Ford F 150

Not finding what you are looking for?

Open Questions:

0 Answers

FZR 400R Deltabox Exup. wont idle properly Howzit everyone. I have a "small" issue with my FZR 400R Deltabox Exup. So it doesn't want to idle properly(the moment I reduce the idle speed to any point below 3000rpm it continues to drop and dies) and also revving the bike it bogs around 6000rpm doesn't go any higher. When restricting the airflow through the airbox it revs better(all the way to 14k rpm) but still doesn't want to idle as the revs then hang on it's way down. I suspected this was all caused by an air leak somewhere, sprayed some quick start on the boots between the carbs and the intake as well as between the airbox and the carbs with no jump in the revs. Nevertheless I sealed the boots just to make sure they aren't the problem. I then stripped the carb and cleaned it properly, put everything back together, sorted out their syncing and reset the mixture screws to 3.5 turns out(which sounds a bit far out, but thats what the manual said-since then I've tried everything from 0.5 to 4 turns out with no significant effect). Then the cylinder started acting up(not firings- a different cylinder about every third time the bike was started) I then replaced the spark plugs with new ones(NGK cr9ek as per the manual) after that cylinder 1,2 and 3 was firing, but 4 was still dead. I Replaced the coil, leads and caps, still not firing. I checked the compression, which was fine, I checked the valve clearance (cylinder 4 the one intake valve was way out of spec, so i replaced the shim), still not firing. I've got no idea what else could be the problem or what to check next. PS. When i pulled the spark plugs(both new and old) they where burnt black so I'm not sure if my jetting could be out of spec perhaps?

Nov 20, 2019 | SPEC Motorcycles

See all 2000 Yamaha XJ 900 S Diversion Questions

2000 Yamaha XJ 900 S Diversion Logo

382 people viewed this question

Ask a Question

Usually answered in minutes!

Top Yamaha Experts

vince

Level 3 Expert

1234 Answers

Steve Sweetleaf
Steve Sweetleaf

Level 3 Expert

1176 Answers

Israel Pineiro Jr

Level 2 Expert

165 Answers

Are you a Yamaha Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...