2001 Kymco Stryker 125 Logo

Related Topics:

Posted on May 18, 2011

Engine starts when put in gear it stalls - 2001 Kymco Stryker 125

1 Answer

Steven Broad

Level 1:

An expert who has achieved level 1.

New Friend:

An expert that has 1 follower.

  • Contributor 2 Answers
  • Posted on Nov 01, 2011
Steven Broad
Contributor
Level 1:

An expert who has achieved level 1.

New Friend:

An expert that has 1 follower.

Joined: Nov 01, 2011
Answers
2
Questions
0
Helped
308
Points
2

Check the switch on the stand may not be opening. normally if you leave the stand down it will cut the engine when you put it in gear, its a safety switch.

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

Starts and runs fine but when I put it in gear it dies

Riding Mower Dies When Put in Gear ' ThriftyFun

www.thriftyfun.com/Riding-Mower-Dies-When-Put-in-Gear.html
It starts fine, but when I put it in gear to go forward or reverse it dies. It also dies ... The engine on my riding mower will start and run while the clutch is pushed in.

Starts and Runs but Dies When put in gear - YSR 50 ' South Bay Riders

www.southbayriders.com > ... > Community > Maintenance and Repair

Aug 25, 2010 - 15 posts - ‎4 authors
The bike will start and run perfectly fine. However, the moment I put it into gear it dies. ----------------- How we got to this point:...

Engine dies in gear, runs in neutral - Hot Rod Forum : Hotrodders ...

www.hotrodders.com > Tech Help > Engine

Jan 4, 2010 - 12 posts - ‎10 authors
But if I drop it into any gear besides neutral or park, the engine will ... In this case, it shifts fine, and on time, however acceleration is ... start. the engine idling rough and wanting to stall when put in gear is the indicator to me.
Jan 21, 2016 • Garden
0helpful
2answers

Car will start but put it in gear engine will die

engine starts with no problem; but, when I put in gear and ...

www.cargurus.com > Questions > Hyundai > Sonata

CarGurusNov 15, 2012 - The engine just fall dead when you step on the gas; it seems to jerk before ... My car does the same thing but i put it in neutral n it starts up. ... I have a 2004 kia optima it jerks when I go into reverse it was driving ... start and run fine butwhen I put it in drive or any other gear it dies! ... 2002 Hyundai Elantra GT.

Engine stalls when tranny put in Drive or Reverse - Kia Forum

www.kia-forums.com/kia-carnival...2002.../43407-engine-stalls-when-tr...

Feb 28, 2008 - 10 posts - ‎3 authors
Give it a little gas before putting in D or R and it will go. .... When I start the van cold and shift the tranny into drive or reverse.....the whole front ... won't run in forward gears - Kia Forum
10 posts
May 25, 2012
Intriguing problem - engine rough idle & hesitation ...
10 posts
Aug 31, 2011
2006 Kia Spectra engine stalls and bad idle, cleaning the ...
10 posts
Aug 30, 2010
2002 Kia Spectra Won't Go Out of Park - Kia Forum
3 posts
Oct 28, 2008
More results from www.kia-forums.com
0helpful
1answer

Start ok wen put in gear stall?

Sounds like a problem with the side stand switch. This switch is in place to do just this. If the sidestand is down and you put in gear the engine will stall for safety.
0helpful
2answers

1999 mazda 626 lx engine stalls when put in any gear

It can be low fuel pressure issue or clogged fuel pump. Or its engine related issues,---------------
Check the help link mentioned below to troubleshoot the problem: ------

Engine stalls, car stalls while starting, vehicle stalls while starting, Engine stalls and dies, Car stalls and stops,
http://alltypesofpartsreplacing.blogspot.com/2012/12/engine-stallscar-stalls-while.html

------
These will help.
Thanks.

1helpful
2answers
0helpful
1answer

Fazer 600 start engine put into rear and it stalls

Hi and welcome to FixYa,

Initially, check, clean, bypass or replace the sidestand switch (blue/yellow wire & ground).

Good luck and thank you for asking FixYa.
0helpful
1answer
3helpful
1answer

1996 evinrude outboard stalls when put in gear idles good in neutral & runs out good in gear but stalls idling in gear

Start by adjusting your idle mixture screw. Start at 1 1/2 turns out and with the engine in gear at an idle slowly turn the screw clockwise until the engine starts to die, then back off a half turn and that will be your proper setting. If you need to you can bump up your idle stop screw just a touch so it will hold also.
Mar 23, 2009 • Boating
1helpful
4answers

Honda keeps stalling

You probably know this but... when you put it into gear you don't have your kickstand down do you. There is an automatic shutoff on the kickstand.
Not finding what you are looking for?

228 views

Ask a Question

Usually answered in minutes!

Top Kymco Experts

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Brad Brown

Level 3 Expert

19187 Answers

littlewheel

Level 2 Expert

122 Answers

Are you a Kymco Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...