My indicators are not working properly when left is turned on it just glows on and right doesnt work at all help plz

Try a reset.

Turn the device on.

Hold down the Power and WPS keys simultaneously for 13 seconds.

Wait for all LED indicators to flash blue 4 times.

This indicates the device has been reset to factory mode.

Generally speaking, symptoms of a bad or failing turn signal bulb are usually the culprit...in your case, either it's the front left or rear bulb. Varies for different vehicle makes...common signs include:

1. turn signal light staying on solid
2. or blinking very fast
3. or either sides of the bulbs stop blinking altogether.

To test this, make sure you reconnect everything you disconnected.
Turn the left signal light on; go to the front of the vehicle, is the turn signal bulb illuminated? If it lights up, even though it is not blinking obviously the bulb is okay. If it doesn't, replace it- problem solved. You'll do the same procedure for the rear turn signal Is that lit up? If not replace the bulb and the problem is solved.
Another common failure is when the turn signal blinks really fast, same procedure as mentioned above.
If both bulbs for the left side and right side illuminate but don't blink, the problem is in the steering column turn signal switch.
If the left or right side blinkers don't work properly at all...then check the integrated hazard warning/turn signal flasher relay- that may be defective; again, that's usually the case if both sides of the signal light don't work.
If you are blowing any fuses related to the flasher system, you have an electrical overload in the turn signal circuitry.

One of the most important safety systems in the car is the Turn signal system. It can help prevent accidents by signalling to other drivers on the road when you need to change course and which way you'll be turning. It is also required by law to have a car dashboard turn signal indicator that works properly. You will need to wire the indicator in your dashboard to the proper lights and locations in the car. For a standard turn signal indicator in which the turn signal lights are the brake lights, please check this link on how you can do this:
How to Wire the Turn Signal Indicator in the Dash

it's the grounds if they're both flashing fast it's definitely grounds take a test light and see if its got power goes through the test light grounded to the frame and if the light comes on then it's definitely your grounds

Well, Lets see, When the Left Blinker front is not working does the bulb turn on BUT, Just doesn't blink. If it turns on and no blink You need to also, check the rear bulb.If eight er one is bad they will NOT blink. The turn indicator on the dash does that blink.. If you find all the bulbs are GOOD
Then, I recommend take out the Front bulb and look into the socket be sure it's clean no rust.
Also, be sure you put the proper bulb in. I know the 1156 bulb looks the same as the 1157.
Be sure, you installed the right part number Let me know.
Mike.

dear,

firstly make all the bulbs glow in the indicator segment.
this will moderate the flasher speed as due to even one bulb fused, causes other bulbs to glow at high rate.

thanx

Concentrate on the front indicator.
With a meter check you have an intermittent supply with the ignition on and left indicator selected.
If its ok, it will be an earth (ground) problem. Check using a temporary earth wire from the indicator unit to the chassis.
If no voltage found at indicator bulb, trace the supply cable back to source.

No power to the glow plugs means no power to the light also. You have a bad fuse or connection to the glow plug relay. Fix that and your good to go. Has nothing to do with your indicator lights on either side of dash. Glow Plug power indicator is labeled THAT and only that.

Replace the turn signal bulb,socket.

need more info ??does it work with hazzards on ??all four lights?'