Question about Crafts & Hobbies
I am having trouble getting power from transformer to track without the wires getting hot. Engine does not have enough power to go around the track. Track is new track is connected wires are connected
my new lionel train slows down on far side of the track There is bad contact in the track connections. You can sand the track connection sites. Another method is to run another power wire to the other
wiring 1122 switches for crossover want to switch so left switch on outer track connects to reversed left switch to make crossover Question is unclear. But if you want both switches to throw at the ...
Question about Crafts & Hobbies
...899v hobby transformer? There are 2 wires from the transformer to the power rail screws on the track. Hook up the wires and watch the direction the engine moves when you move the lever to
Question about Bachmann Crafts & Hobbies
electric train set stop and goes when it goes over certain parts of the tracks do I need to clean the tracks or the wheels and what do I use to correct this issue? 1: make sure all track connections ...
Wires disconnected from track Wires came off terminal section of track and I don't know how to reconnect them. Power wire to the center track and ground to the other terminal. You can turn ...
Question about Lionel Crafts & Hobbies
...signal. I have the two break sections on each end of the middle section but when the power to the track is on, the Gate stays down until we stop the train. Do you know what I am doing wrong? The ...
CANNOT GET THE UNCOUPLING TRACK SECTION TO WORK THRU TRACK POWER - WHAT IS PROPER WAY TO HOOK UP RED AND BLACK WIRES? LIONEL FASTRACK Track power is not recommended for this uncoupler. Use an aux ...
How to wire a Lionel block signa lwith insulated track. Only one outside rail has to be insulated from other sections. A hot wire goes to the signal block. The other wire from the signal ...
...no power. I would suggest that the controller is correct and there is a short circuit. If this is so then there would not be any power on the track. Check the wiring from the controller to the
30 questions posted
Usually answered in minutes!
33 Questions
31 Questions
7 Questions
6 Questions