2008 Honda Accord "maf sensor 5 wires" Questions

Question about Honda Accord

Which are the functional iat sensor wires on an

MAF/IAT sensor connector, Pin #4, GREEN/BLACK is the "sensor ground" and Pin #5, RED/YELLOW is the "sensor input" for the IAT. For the 3.5L engine: At the MAF/IAT sensor connector, Pin

Question about Cars & Trucks

3 Answers

Wiring going to MAF sensor on 1996 chevy truck 5.7l

...MAF sensor on 1996 chevy truck 5.7l i have a 1996 chevy truck 5.7l and would like to know wHere the wiring Point? to MAF sensor are coming from and the device name and pin number. thank You for any ...

Question about Honda Accord

1 Answer

For a 2005 GMC yukon 5.3L what are the wire colors that control the IAT sensor There should only be 2 wires controlling it but there are 5 on the connection as it controls the MAF and IAT with the sa

wires for the IAT sensor? The intake air temp sensor is part of the MAF sensor so yes there are 5 wires. The two wires that go to the air temp sensor are tan and black. The other three are for the MAF

Question about Honda Accord

1 Answer

How to check a 2009 chev cobolt MAF/IAT 5 wire

...to check a 2009 chev cobolt MAF/IAT 5 wire sensor and what should i get for my reading for the 5 wires/ what color are the two wires for the maf/iat sensor in a 5 wire plug on a 2008 cobalt LS

Question about Honda Accord

1 Answer

I have a 4runner and i would just want to know the

...maf sensor and i do,t know which are the wires for the iaty sensor It should be a yellow wire with a black stripe, it is called the THA terminal and is on pin number 7 at the MAF. You can use pin 5 ...

Question about Cars & Trucks

2 Answers

13 Polaris Ranger 500 found bad wires on maf sensor repaired those and replaced sensor, now starts and dies. I replaced the fuel pump, injector and temp sending unit The tps has 5 volts going to it

...maf sensor repaired those and replaced sensor, now starts and dies. I replaced the fuel pump, injector and temp sending unit The tps has 5 volts going to it What is the TPS output measurement ? Have ...

Question about Honda Accord

1 Answer

I got a p0113 code for the mass air flow sensor on

...MAF) sensor connector, backprobe the Gray (GY) wire at terminal #6 with the key on and the MAF sensor connected. Typical voltage will be about 2-3.5v depending on temperature. 2. If the voltage is ...

Question about Honda Accord

2 Answers

Buick regal 2002 gs...when i stop at a light the

...MAF) sensor or circuit. Other MAF sensor circuit DTC trouble codes are P0101, P0102, P0103, and P0104. Symptoms: You will likely not notice any serious drivability problems, although there may be ...

Question about Honda Accord

1 Answer

I failed my inspction the

...MAF)sensor. The MAF sensor is located inside the air inlet duct near the throttle body. The mount and electrical connector is outside the duct. The MAF is basically a hot wire in the airflow stream. ...

Question about Honda Accord

1 Answer

Want to get directions to remove mass air flow sensor in order to inspect it for possible replacement- check engine light is on

...MAF) sensor measures the amount of air which passes through it. The ECM uses this information to determine the operating condition of the engine, to control fuel delivery. A large quantity of air ...