I have a vision T9500 treadmill. My husband was recalibrating and it got stuck in the highest position and is displaying E5 in the window. Any ideas how to get it down? hi, Try AUTO-CALIBRATION first.
...getting an error message: E6 Typically an E6 error message indicates that the machine needs to be recalibrated because the elevation motor is out of range or that you have a loose cable connection. ...
error lines in function area adjust the reed switch, see the diagram attached , clean, and tight the wires very well.RUN the software calibration for diagnose, and troubleshooting.If you can not run ...
my vision fitness t9450hrt stopped mid run yesterday and the belt wont move..the inclene still works and everything else works fine i have took the cover off checked the drive belt from the motor and ...
...use the elevation keys to get to "eng4" and hold enter for 3 seconds - then press start - this will calibrate your machine and confirm if there is any speed reading issues. If your machine displays ...
error messages error lines Dear Sir:Adjust the reed swtich see the diagram attached, clean, and tight the connector very well.tight the ribbon cable from keypad, and connector for display board vs ...
Treadmill overspeed. After a few minutes of normal operation the treadmill RPM goes UP to the max and later stops. I try to perform the calibration but after running at slow speed the treadmill stops ...
...power source). Make sure the circuit is not overloaded. Make sure the circuit is NON-GFI. 2. Calibrate (See engineering mode for specific treadmill). 3. If calibrations do not hold, replace ...
Question about Vision Fitness Exercise & Fitness
m tf40 vision fitness treadmill wont change incline or speed only just got today Please RUN the software calibration for easy diagnose, troubleshooting and fix it. see the diagram attached. God bless ...
112 questions posted
Usually answered in minutes!
4 Questions