Epic 425 Mx Treadmill EPTL88105 ! "incline calibration start stop" Questions

...incline calibration is to start the treadmill, push the incline up button and then after you release the button, remove the safety key. Replace the safety key and the treadmill should calibrate. If ...

Incline is not working properly, it goes all the way up and down a little and it stops, motor seems to be working properly but cannot calibrate on incline 0% or work properly treadmill seems to be ...

...incline calibration. Use this process. Hold the stop and speed up buttons simultaniously, while inserting the safety key. This will put you in diagnostics. Then press the stop button one time. Then ...

...the safety key off. Release the incline up button and replace the safety key. The treadmill should go to maximum incline then minimum. after calibration is completed, retry the treadmill

...incline system may need to be calibrated. To initiate the calibration routine follow the steps below. Step 1 Place the key into the machine. The key's slot is located on the bottom of the console, ...

incline calibration. It will run to fully inclined, then to minimum incline. It should not do this every time you want to operate the machine, but they will do it automatically if the operation of the

...calibration, and the "314" code does not appear. I get a "728" code that appears. So I tried to proceed through anyways to E91 and it starts to calibrate by raising the incline all the way and then ...

...CALIBRATION 1. Turn off treadmill. 2. Simultaneously press PROGRAM, ENTER, and START/STOP for about 3 seconds. 3. Maximum speed will be shown in the TIME/PACE display followed by an "E" for English ...

incline should go through their full range from lowest to highest, and then back down again. Step 4 Repeat the process if the display does not read "Calibration Successful." Contact the business where

...incline calibration. Restore factory defaults. If necessary, press the Restore Defaults button to reset the firmware to the original factory firmware. This will erase all firmware updates that you ...