...incline sensor may be defective. The sensor is the black cap/wire coming out of the top of the motor. Make sure it is connected properly. If the sensor is defective, you have to order the complete ...
Question about Nordic Track Exercise & Fitness
...incline sensor may be defective. Be sure all the plugs are secure on the controller board. If the sensor is defective, you will need to order a new incline motor.. If the incline motor does not move ...
...should function correctly. If not, you may have a damaged wiring harness (caused during assembly) or a defective incline sensor. If the sensor is defective, you will need to replace the incline
incline sensor to the power board. If all looks normal, put it back in calibration and see if you see a blinking ?- -? symbol in the incline window when you are calibrating. If not, the incline sensor
...incline motor. It is not the sensor. I have been repairing treadmills for 15 years and incline sensors seldom if ever go bad. If can isolate the incline motor using a 110 volt power cord, this may ...
Question about Icon Exercise & Fitness
incline sensor to the power board. If all looks normal, put it back in calibration and see if you see a blinking ?- -? symbol in the incline window when you are calibrating. If not, the incline sensor
...maximum elevation, then back down. If the motor moves and then resets, you may have an incline motor sensor defect. You will need to order a new incline motor. The sensor is not available
...incline sensor has failed. It is a reed switch snapped into the side of the incline motor, 2 black wires that plug into the controller.. You can buy the sensor separately from the motor. Contact Icon ...
...twice.. If it all works well. the incline will work correctly, if not you may need the incline sensor replaced. Unfortunately, you cannot order the sensor separately, you will have to order the
...incline lights work fine,go from lowest to highest in 3 pushes per increment.after initial power on lower/raise, motor doesn't work. Dear Sir:I STRONG recommend RUN the calibration Software ...
171 questions posted
Usually answered in minutes!
67 Questions
16 Questions
20 Questions
11 Questions
5 Questions